$37.99
11 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Every direct impingement AR runs on the same basic idea: hot gas gets tapped off the barrel and routed back to cycle the bolt, and the gas block is what makes that handoff happen. This LBE Unlimited low profile gas block is built for guys running a slim free float handguard who do not want a big front sight tower eating up rail space. It clamps to a .750 inch gas journal and stays low enough to disappear under nearly any modern handguard, leaving the top rail open for optics and the sides open for lights or grips.
What sets this particular version apart is that it ships with the pistol length gas tube already installed at the factory. That means no lining up the gas key, no driving a roll pin through a tube that is fighting you, and no guessing whether everything is seated straight. LBE pins the tube to the block before it ever leaves their shop, so the whole assembly drops onto the barrel as one unit. Pistol length gas systems like this one are meant for short barrels, typically 10.5 inches and under, where there simply is not enough real estate for a carbine or mid length system to work properly.
The block itself is machined from 4142 steel, which is the same material a lot of higher end blocks use because it holds up to the heat and pressure cycling through it thousands of times without warping or loosening. The black nitride finish adds a layer of corrosion resistance on top of that and gives it a finish that matches most black AR builds without any touch up needed. The gas tube runs off 304 stainless seamless tubing, which resists the discoloration and pitting that plain steel tubes tend to pick up after a season of range trips.
Installation on your end is about as simple as it gets. Set screws are included for locking the block onto the barrel, and since the gas tube is already pinned to the block, you are really just clamping one assembly into place and sliding your handguard over the top. It is a straightforward swap for anyone building a short barreled AR pistol or replacing a tired factory gas block, and it plays well with basically any low profile compatible handguard on the market.
Yes, the pistol length gas tube is pinned to the gas block at the factory before it ships. You are not stuck timing the gas key or driving a roll pin yourself, you just mount the whole assembly onto your barrel as one piece.
This gas block is sized for a standard .750 inch gas journal, which covers the vast majority of AR-15 barrels on the market. The pistol length gas tube pairs with barrels around 10.5 inches or shorter, since that is where the gas port sits close enough to the chamber for reliable cycling.
That is the whole point of a low profile design. It sits flat against the barrel with no front sight tower or bulk sticking up, so it tucks under nearly any free float rail on the market without interference.
It is machined from 4142 steel, a common choice for gas blocks because it handles repeated heat and pressure cycles without losing its shape. The black nitride finish adds extra corrosion resistance and keeps the surface looking clean after regular use.
| UPC | 706612408011 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | ARLGB-PBLK |
| Color | Black |
| Product Type | Gas Block |
You must be logged in to post a review.
Reviews
There are no reviews yet.