$116.16
2 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The 6mm PPC Sako Bushing Full Length Sizing Die from L.E. Wilson is the tool you reach for when you want consistent, repeatable brass without overworking it. It sizes the case body and shoulder while letting you set neck tension with the correct interchangeable bushing, and it decaps the case in the same stroke. This is the factory/Sako version, cut for brass fired in standard factory-dimension chambers rather than a tight benchrest match chamber, so if your 6 PPC brass came out of a Sako or similar factory-spec rifle, this is the one that fits.
Unlike a plain neck die, this one works the whole case. It brings the body back down, pushes the shoulder where you want it, and controls neck tension all at once, which keeps your rounds chambering smooth round after round. The adjustable-depth decapping rod means you set the knock-out punch exactly where you like it, and L.E. Wilson includes an extra decapping punch in the box so you have a spare on hand. There is no expander ball dragging through the neck, so your tension comes purely from the bushing you choose.
Bushings are sold separately, which is the whole point of a system like this. You pick the size that matches your brass and your preferred grip on the bullet, and you can swap bushings any time you change brass lots or want to tune for a load. The die itself is made in the USA from high quality heat treated steel, harder than a Grade 8 bolt, with stainless parts for a long-lasting finish. It threads into any standard 7/8-14 reloading press.
Like most of the Wilson lineup, this die rewards a little measuring. Running your sized brass through an L.E. Wilson case gage lets you confirm your shoulder bump and keep from pushing the shoulder back too far, which is how you stretch case life and keep headspace honest. Set it once, check your work, and you have a repeatable process that holds up for a long time.
The Sako version, also called the Factory version, is dimensioned for brass fired in standard factory-spec chambers like those found in Sako rifles. The Match die is cut tighter for brass fired in a benchrest match chamber. Picking the one that matches your rifle's chamber keeps your sizing consistent and your brass fitting right.
Yes, the bushing is sold separately. That is by design, since it lets you choose the exact size that gives you the neck tension you want. Measure a loaded round's neck diameter and subtract your desired tension to land on the right bushing size, and you can keep a few on hand to tune different brass or loads.
No, it does not use an expander. Your neck tension comes entirely from the bushing you select, so there is no expander ball being dragged back through the neck. That approach helps keep necks concentric and runout low.
Yes. It threads into any standard 7/8-14 reloading press, which covers the vast majority of single-stage and progressive presses out there. Just thread it in, set your shoulder bump, and you are ready to go.
| UPC | 815145026064 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | FLD-6PPCF |
You must be logged in to post a review.
Reviews
There are no reviews yet.