$135.52
4 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The L.E. Wilson 30 BR Micrometer Top Bullet Seater is one of those tools that makes you rethink how good your handloads can really be. Instead of guiding the case up into a die like a conventional threaded setup, this chamber-type seater holds the case completely stationary and presses the bullet straight down into the neck. The case and bullet are captured in a cavity that mimics a rifle chamber, so everything is already aligned before the stem ever touches the bullet. The result is minimal runout and the kind of consistency that 30 BR benchrest guys have chased for generations.
Machined from high-grade stainless, this die has essentially one moving part during the seating operation, which keeps slop out of the equation. The seating stem and guide hole are cut to such tight tolerances that the fit is nearly perfect, and some folks note the stem fits snug enough to pull a vacuum. That precision is exactly what keeps your bullets sitting true to the centerline of the case, pull after pull.
The micrometer head is the big draw here. It adjusts seating depth in clean .001" graduations, so finding your rifle's sweet spot is a matter of counting clicks rather than guessing and re-measuring. If you load for multiple bullets or want to record settings and jump back and forth, you just note the number on the scale and return to it later. It takes a lot of the fuss out of load development.
This is a hand die, so it's designed to run with an arbor press for the best feel and control, though a soft-faced mallet will do in a pinch at the range. Drop a charged, primed case and a bullet into the die body, set it on the base, and press the cap until it bottoms out. The included base lifts the primer above the press plate so nothing contacts the primer during seating. It's a fast, repeatable rhythm once you find it, and it travels well for loading right at the bench.
An arbor press gives you the best feel and control, and it's how most precision loaders run these dies. That said, you can seat bullets with a soft-faced mallet if you're in a pinch or loading at the range. It is a hand die, so it is not meant for a conventional threaded press.
The case and bullet are fully captured inside a chamber-like cavity before the stem presses the bullet straight down, so both stay aligned through the whole operation. Holding the case stationary instead of sliding it into the die cuts down on runout. Less runout means your bullets sit truer to the bore, which shows up on target as tighter groups.
The micrometer top is graduated in .001" increments, so you can dial seating depth precisely and repeat it. If you switch between bullets or rifles, just record the setting and return to it later. It takes the guesswork out of chasing your rifle's preferred seating depth.
The base sits under the die body on your arbor press and raises the loaded round up off the press plate. That keeps the primer from resting against a hard surface during seating. It's a small piece but an important safety and consistency touch.
| UPC | 815145022523 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | S30-BR |
You must be logged in to post a review.
Reviews
There are no reviews yet.