Description
If you run a Forster Bushing Bump Neck Sizing Die or a Bushing Full Length Sizing Die, this .229" bushing is how you fine-tune the single most important detail in neck sizing: bullet tension. Instead of relying on the chamber or a one-size expander ball, the bushing sizes the neck based on your actual brass wall thickness, so you get the exact amount of grip you're after. That translates to straighter necks, better concentricity, and ammo that shoots the way you want it to.
Forster puts these through a super-cooling cryogenic process, which closes up and refines the surface of the steel for an ultra smooth finish. Each one is heat treated and then honed to the precise inside diameter marked on the bushing, so what you read is what you get at the press.
Where the .229" Bush-229 Fits In
Bushings come in .001" increments, which is what makes custom neck sizing possible. The general rule of thumb is to pick a bushing roughly .002" smaller than a loaded round measures at the case neck, and go .003" smaller if you want a bit more press fit. Many handloaders keep a few neighboring sizes on hand so they can adjust as brass work-hardens over time, since fired-many-times brass often needs a slightly smaller bushing to hold the same grip.
Smooth Sizing From the .229" Neck Bushing
That polished interior isn't just marketing. A clean, slick bore on the bushing means the neck slides through without galling or chatter, which keeps runout down and makes the whole sizing stroke feel consistent. It's one of those small parts that quietly does a lot of the work when you're chasing tight groups.
One thing worth knowing up front: Forster bushings are built for Forster dies. They are not cross-compatible with Redding or L.E. Wilson bushing dies, so if you're running a Forster setup, you're in the right place.
Key Specifications
- Manufacturer: Forster Products
- Manufacturer Part Number: BUSH-229
- Model: Bush-229
- UPC: 757253998782
- Inside Diameter: 0.229 in
- Material: Steel, cryogenically treated and heat treated
- Interior Finish: Honed to precise marked inside diameter
- Sizing Increment Family: Available in 0.001 in increments
- Compatibility: Forster Bushing Bump Neck and Bushing Full Length Sizing Dies
- Not Compatible With: Redding and L.E. Wilson bushing dies
- Country of Origin: USA
What’s Included
- One (1) Forster .229" neck bushing (Bush-229)
Frequently Asked Questions
What dies does the Forster .229" neck bushing work with?
This bushing is made for Forster Bushing Bump Neck Sizing Dies and Forster Bushing Full Length Sizing Dies. It is not compatible with Redding or L.E. Wilson bushing dies, so plan on running it in a Forster setup.
How do I know if .229" is the right bushing size for me?
A good starting point is to measure the neck diameter of a loaded round and pick a bushing about .002" smaller than that measurement. If you want more bullet grip, go about .003" smaller instead. Since bushings come in .001" increments, many reloaders keep a couple of neighboring sizes on hand to fine-tune neck tension.
Why are Forster bushings cryogenically treated?
The super-cooling cryogenic process refines and closes up the surface of the steel, giving the bushing an ultra smooth interior. That smoother finish helps the case neck size cleanly, which produces straighter, more consistent loaded rounds.
Does the bushing diameter match the final neck tension exactly?
Not quite, because your brass neck wall thickness plays a big role. The bushing sizes the outside of the neck, and the thickness of that brass determines how far the neck is actually squeezed down. As brass work-hardens after several firings, you may need to step down to a slightly smaller bushing to keep the same grip.




Reviews
There are no reviews yet.