Description
This Forster .264 neck bushing (part number BUSH-264) is the little precision part that lets you take real control over neck tension on your reloads. It drops into Forster's Bushing Bump Neck Sizing Die and Bushing Full Length Sizing Die, giving you the ability to size the case neck to an exact inside diameter instead of settling for whatever a standard die hands you. That kind of control is what separates good brass prep from great brass prep.
What the .264 Forster Bushing Brings to the Bench
Forster takes these bushings a step past the usual. The steel is run through a super-cooling cryogenic process that refines and tightens the surface, then each bushing is heat treated and honed to the precise inside diameter stamped on it. The result is a smooth, consistent sizing action that works your brass gently and holds its dimension over a long service life. Bushings come in .001 inch increments, so you can fine tune for your exact brass and the neck tension you are after.
Picking the Right Neck Bushing Size
The standard approach is to measure the outside neck diameter of a loaded round and subtract about .002 inch to land on your starting bushing. You can also calculate it with neck wall thickness times two, plus bullet diameter, minus .002 inch. The .264 size is a common pick for necks on the smaller side of the 6.5mm family and similar cartridges, but always measure your own loaded rounds since brass thickness varies lot to lot. Many handloaders keep a couple of bushings on hand a thousandth or two apart to tune tension once they see how their brass springs back.
A Note on Compatibility
These are Forster bushings built for Forster dies. They are not cross compatible with Redding or L.E. Wilson bushing dies, so make sure you are running a Forster bushing setup before adding this one to your kit. For the cleanest results, bushing sizing pairs best with brass that has uniform neck walls or has been neck turned.
Key Specifications
- Manufacturer: Forster Products
- Manufacturer Part Number: BUSH-264
- UPC: 757253998645
- Diameter: .264 inch
- Material: Heat treated, cryogenically treated steel
- Finish: Honed to precise inside diameter
- Type: Neck sizing bushing
- Compatibility: Forster Bushing Bump Neck and Bushing Full Length Sizing Dies
- Size Increments: Available in .001 inch steps
- Quantity: 1 bushing
- Country of Origin: USA
What’s Included
- One Forster .264 diameter neck bushing (BUSH-264)
Frequently Asked Questions
What dies does the Forster .264 neck bushing fit?
It fits Forster's Bushing Bump Neck Sizing Die and the Bushing Full Length Sizing Die. It is designed specifically for Forster bushing dies and is not compatible with Redding or L.E. Wilson bushing dies. Make sure you have a Forster bushing setup before ordering.
How do I know if .264 is the right bushing size for my brass?
Measure the outside neck diameter of a loaded round with your chosen brass and bullet, then subtract about .002 inch to get your starting bushing size. You can also use the formula of neck wall thickness times two, plus bullet diameter, minus .002 inch. Since brass thickness varies, it is smart to measure your own loaded rounds rather than assume.
Why are Forster neck bushings cryogenically treated?
Forster runs the steel through a super-cooling cryogenic process that refines and closes the surface of the metal. This produces an ultra smooth bore that sizes necks gently and consistently, which helps you build straighter, more uniform loaded rounds. The bushings are also heat treated and honed to the exact inside diameter marked on them.
Should I buy more than one bushing size?
Many handloaders keep a few bushings a thousandth or two apart so they can fine tune neck tension. Brass springs back slightly after sizing, so a slightly smaller bushing may be needed to reach the grip you want. Bushings are sold in .001 inch increments to make that kind of tuning easy.





Reviews
There are no reviews yet.