Description
Neck tension is one of those details that separates good handloads from great ones, and a quality bushing is how you take control of it. This Forster .266 inch neck bushing (part number BUSH-266) drops into Forster Bushing Bump Neck Sizing Dies and Bushing Full Length Sizing Dies, letting you size the case neck to the exact inside diameter your brass and bullet combination calls for. Because the bushing does the sizing instead of an expander ball, you set your neck tension by picking the right diameter rather than fighting inconsistent brass.
What the .266 Neck Bushing Does for Your Loads
Forster offers these bushings in .001 inch increments, which is what makes custom neck sizing possible. The general rule most reloaders follow is to pick a bushing roughly .002 inch under the neck diameter of a loaded round. Measure the neck of a loaded cartridge, do the math, and this .266 lands right where you need it for a lot of 6.5mm and .264 bullet builds. Dialing in that tension gives you more uniform seating force and tighter groups down range.
How the BUSH-266 Is Built
Forster machines these bushings to a superior interior finish for what they call smooth as silk sizing, and that polish is not just marketing. The bushing is heat treated and honed to the precise inside diameter stated, then run through a super cooling cryogenic process. Cryogenic treatment refines and closes the surface of the steel, which means less drag on the case neck and a bushing that holds its dimension over a long working life.
One important note on fit: Forster bushings are designed for Forster dies and are not interchangeable with Redding or L.E. Wilson bushings, so make sure your die is a Forster unit before ordering. If you already run a Forster bushing setup, keeping a spread of sizes on hand lets you fine tune for different lots of brass without buying a whole new die.
Key Specifications
- Manufacturer: Forster Products
- Manufacturer Part Number: BUSH-266
- UPC: 757253998621
- Inside Diameter: 0.266 in
- Material: Heat treated, cryogenically treated steel
- Finish: Honed and polished interior
- Compatibility: Forster Bushing Bump & Bushing Full Length Sizing Dies
- Size Increments Available: 0.001 in
- Quantity: 1 bushing
- Country of Origin: USA
What’s Included
- One (1) Forster .266" neck bushing (BUSH-266)
Frequently Asked Questions
Which dies does the Forster .266 neck bushing fit?
This bushing is made for Forster Bushing Bump Neck Sizing Dies and Forster Bushing Full Length Sizing Dies. It is not compatible with Redding or L.E. Wilson bushings, so confirm you are running a Forster die before ordering. If your setup is Forster, this drops right in.
How do I pick the right bushing size for my brass?
Measure the neck diameter of a loaded round, then choose a bushing roughly .002 inch smaller than that measurement. Forster offers these in .001 inch increments so you can fine tune neck tension for your specific brass and bullet combo. Keeping a couple of sizes on hand lets you adjust between different lots of brass.
What makes Forster neck bushings different?
Each bushing is heat treated and honed to the stated inside diameter, then run through a cryogenic process that refines and closes the surface of the steel. The result is a very smooth interior that reduces drag on the case neck and holds its dimension over a long service life. That consistency is what helps produce straighter, more uniform loaded rounds.
Does the bushing size the whole case?
No, the bushing only sizes the case neck. In a Bushing Bump die it handles the neck and lets you bump the shoulder without touching the case body, which keeps necks straighter and lets you control bullet tension precisely. The expander ball is left out of the equation, so your bushing choice sets the internal neck diameter.




Reviews
There are no reviews yet.