Description
If you neck size your 7mm-08 brass to stretch case life and keep accuracy tight, you eventually run into cases that fight you at the bolt. That's exactly where the Redding Body Die earns its keep. It resizes the full length of the case body and bumps the shoulder back into spec without ever touching the neck, bringing stubborn brass right back to easy chambering.
What the Redding 7mm-08 Body Die Does
This die is built without internal parts. It won't deprime or size the neck, and that's the whole point. By leaving the neck alone, you preserve the tension you set with your neck sizing die while trimming the body back to proper dimensions. Like any standard sizing die, you control the amount of shoulder bump by adjusting the die's position relative to the shellholder, which makes it easy to dial in minimal headspace for a bolt gun. Pairing it with a Redding Competition Shell Holder set gives you repeatable, measured bump without a lot of guesswork.
Pairing the Body Die with Your 7mm-08 Setup
Most handloaders run this alongside a bushing-style neck die such as a Redding Type S Neck Die or a Competition Neck Sizing Die. The neck die handles tension, the body die handles the body and shoulder, and together they let you work the brass as little as possible. That's a popular route for folks chasing long case life and consistent groups out of the same rifle.
Built to Redding Standards
Redding has a long reputation among precision handloaders, and this die carries the same tight tolerances and quality steel they're known for. It threads into any standard 7/8"-14 press and uses the #1 shellholder for 7mm-08 Remington. Keep in mind the shellholder is sold separately, so grab the correct one if it isn't already in your kit. For anyone serious about getting the most reloads out of their 7mm-08 brass, this is a smart addition to the bench.
Key Specifications
- Manufacturer: Redding
- Manufacturer Part Number: 75139
- UPC: 611760751394
- Cartridge: 7mm-08 Remington
- Die Type: Body Die
- Bullet Diameter: 0.284"
- Required Shellholder: #1 (sold separately)
- Thread Size: 7/8"-14
- Number of Dies: 1
- Internal Parts: None (does not size neck or deprime)
What’s Included
- One Redding 7mm-08 Remington Body Die with lock ring
- Die storage box
Frequently Asked Questions
Does the 7mm-08 Remington Body Die size the case neck?
No. The body die full-length sizes the case body and bumps the shoulder back for proper chambering, but it leaves the neck completely untouched. You'll size the neck separately with a dedicated neck die to set your neck tension.
What shellholder do I need for this Redding body die?
The 7mm-08 Remington uses the #1 standard shellholder, which is not included with the die. Many precision handloaders also use a Redding Competition Shell Holder set to fine-tune and repeat shoulder bump measurements.
Will this die deprime my brass?
No, the body die is made without internal parts, so it has no decapping rod or pin. It is intended strictly to resize cases that have become hard to chamber after repeated firing and neck sizing. Depriming is handled during your neck sizing or a separate step.
What should I pair the 7mm-08 Body Die with?
It's designed as a companion to bushing-style neck dies like the Redding Type S Neck Die or Competition Neck Sizing Die. Running the two together lets you control neck tension and body dimensions independently, which helps stretch case life and keep your groups tight in a single rifle.




Reviews
There are no reviews yet.