Description
If you run a Redding bushing-style neck sizing die and want tighter control over how much your case necks get worked, this is the piece that makes it happen. The .302" steel bushing (part number 73302) lets you set the exact amount of neck tension you want so you're holding the bullet securely without over-sizing the brass. Less working of the neck means longer case life and more consistent seating, which is what a lot of handloaders are chasing when they move to a bushing setup in the first place.
What the .302 Redding Steel Bushing Is Built For
This one is made from heat-treated steel, and the sizing diameter is hand polished to a surface hardness of Rc 60-62. That hardness and polish translate to reduced sizing effort and a cleaner feel on the downstroke. Every bushing in this line measures a standard 1/2" outside diameter by 3/8" long, so it freely interchanges across all Redding bushing-style neck sizing dies with no fuss.
Picking the Right Size for Your Brass
The .302 Redding bushing covers one specific step in the full range, which runs from .185" through .368" in .001" increments. To figure out what you need, measure the outside neck diameter of a loaded round with a good micrometer, then subtract about .001" to allow for brass spring-back and proper bullet grip. If you're loading moly-coated bullets, you may want to step down another thousandth or two for tighter necks. Having a couple of sizes on hand is smart since small tweaks can make a real difference in how your loads shoot.
Why Handloaders Reach for Redding Bushings
Redding has a long reputation for turning out precise, repeatable reloading gear, and these bushings are a big part of that story. They're a favorite with folks who want to fine-tune accuracy without buying a whole new die. Drop one in, size a few, and you'll see why precision reloaders keep a drawer full of them sorted by thousandth.
Key Specifications
- Manufacturer: Redding
- Manufacturer Part Number: 73302
- UPC: 611760733024
- Diameter: .302 in
- Material: Heat-Treated Steel
- Surface Hardness: Rc 60-62
- Outside Dimensions: 1/2" O.D. x 3/8" long
- Style: 73 Style Bushing-Type Neck Sizing
- Quantity: 1
- Available Range: .185" to .368" in .001" increments
What’s Included
- One (1) Redding 73 Style .302 steel neck sizing bushing
Frequently Asked Questions
Which dies does the Redding .302 steel bushing fit?
It freely interchanges in all Redding bushing-style neck sizing dies, including the Type S line. Because it uses the standard 1/2" outside diameter by 3/8" length, there's no adjustment needed to swap it in and out. Just drop it into the bushing seat and you're ready to size.
How do I know if the .302 is the right bushing size for me?
Measure the outside neck diameter of a loaded cartridge with a precision micrometer, then subtract about .001" to account for brass spring-back and bullet tension. If that math lands you right around .302", this is your bushing. Loading moly-coated bullets can call for a size or two smaller for tighter necks.
What's the difference between this steel bushing and the titanium nitride version?
Both share the same dimensions and both are hand polished to Rc 60-62 hardness. The titanium nitride bushings add a surface coating that bumps up hardness a little more and cuts sizing friction further. The heat-treated steel version here handles the job well and is the go-to for plenty of precision handloaders.
Does this bushing only size the neck of the case?
Yes, these are neck sizing bushings designed to work the case neck down just enough to hold a new bullet with the tension you choose. That controlled approach reduces how much the brass gets worked, which helps with case life and consistency. It will not size the body or shoulder of the case on its own.





Reviews
There are no reviews yet.