Description
If you're running a Redding bushing-style neck sizing die, this .291 steel bushing lets you take real control over how tight your necks grip the bullet. Instead of overworking your brass with a one-size-fits-all die, you pick the exact bushing that gives you the neck tension your load likes. That kind of control is where consistent groups come from, and it's why handloaders chasing accuracy lean on this system.
What the .291 Redding Steel Bushing Does
This bushing is machined from heat-treated steel with a surface hardness in the Rc 60-62 range, and the sizing diameter is hand polished to cut down on sizing effort and keep brass flowing through smoothly. It carries a true .291 inch inside diameter, and like the rest of the line, it's marked right on the bushing so you always know what you grabbed out of the box. All of these share the same 1/2 inch O.D. by 3/8 inch length footprint, so swapping sizes takes seconds.
Fitting the Redding 73 Style Bushing to Your Die
These freely interchange across all of Redding's bushing-style neck sizing dies, including the Type S and Competition dies. The full lineup runs in .001 inch increments from .185 up to .368, covering calibers from .17 all the way through .338, so once you've got a die set up, building out a range of sizes is easy. To land on the right one, measure the outside neck diameter of a loaded round with a good micrometer, then subtract about .001 to .002 inch to account for brass springback and the tension you want on the bullet.
Redding has been building reloading gear in the USA for decades, and these bushings are a big reason their system has such a loyal following among precision reloaders. If your measured neck calls for .291, this is the piece that gets you there.
Key Specifications
- Manufacturer: Redding
- Manufacturer Part Number: 73291
- UPC: 611760732911
- Bushing Diameter: .291 in
- Material: Heat-Treated Steel
- Surface Hardness: Rc 60-62
- Finish: Hand Polished
- Dimensions: 1/2 in O.D. x 3/8 in Long
- Style: 73 Style Neck Sizing Bushing
- Compatibility: All Redding Bushing-Style Neck Sizing Dies
- Country of Origin: USA
What’s Included
- One Redding 73 Style .291 heat-treated steel neck sizing bushing
Frequently Asked Questions
Which dies does the Redding .291 steel bushing fit?
It freely interchanges in all of Redding's bushing-style neck sizing dies, including the Type S and Competition sizing dies. Every bushing in the line shares the same 1/2 inch O.D. by 3/8 inch length, so you can swap diameters without any fuss. As long as your die is set up to take neck bushings, this one drops right in.
How do I know if .291 is the right bushing size for my load?
Measure the outside neck diameter of a loaded cartridge with a precision micrometer, then subtract about .001 to .002 inch. That accounts for brass springback and gives you the neck tension to hold the bullet without overworking the brass. If that math lands you near .291, this is your bushing.
What is the Redding bushing made of and how hard is it?
This is a heat-treated steel bushing with a surface hardness in the Rc 60-62 range. The sizing diameter is hand polished to reduce sizing effort and keep brass moving smoothly. Steel bushings are a popular choice for their durability and value in the Redding lineup.
Why use a bushing die instead of a standard full-length sizer?
A bushing setup lets you choose exactly how much you size the neck, so you can tune neck tension rather than accept whatever a fixed die gives you. That control helps brass last longer and often tightens up groups. It's one of the main reasons precision handloaders reach for the Redding bushing system.



Reviews
There are no reviews yet.