$135.52
5 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
If you chase tight groups with your 300 WSM, bullet seating is one of the last variables standing between you and consistent numbers downrange. This L.E. Wilson micrometer seater is a chamber-type, inline design that benchrest and precision crowd have leaned on for generations. The case and bullet are captured inside a chamber cut much like your rifle's, then the seater stem presses the bullet straight down into the neck. Everything is aligned before any pressure is applied, which is how Wilson keeps runout down to the kind of numbers precision loaders obsess over.
This is a hand die built for an arbor press, not a conventional threaded press. You drop a charged and primed case into the die body, set your bullet, slide it onto the included base, and press the cap down until it bottoms out. There's effectively one moving part during the seating stroke, and the fit between stem and body is tight enough to pull a vacuum. That simplicity is exactly why it stays consistent round after round. A soft-faced mallet works in a pinch, but an arbor press is the way to get the most out of it.
The micrometer head is the star here. It's graduated in .001" increments with a clean, laser-engraved scale, and you can split those marks finer if you're really hunting for the node. Larger adjustments happen through the 3/8"-24 threaded cap, while the micrometer handles the fine tuning. Because the whole unit is compact and simple, plenty of folks toss it in the range bag to test seating depth against the lands right at the bench.
Wilson machines these from solid bars of high-grade stainless steel, so you get a tool that shrugs off wear and holds its tolerances year after year. It's made in the USA and fits right in with F-Class, PRS, High Power, and long-range hunting setups where every little bit of consistency counts.
No, this is a chamber-type hand die designed for use with an arbor press. You can seat bullets with a soft-faced mallet if needed, but an arbor press gives you the best feel and consistency. It's not made to thread into a conventional 7/8"-14 press.
The micrometer head is graduated in .001" increments with an easy-to-read laser-engraved scale, and you can split those marks even finer if you're chasing a precise node. Larger seating changes are handled through the 3/8"-24 threaded cap, while the micrometer takes care of the fine tuning. That combination makes dialing in and returning to a setting quick and repeatable.
The chamber-type design captures both the case and bullet in a chamber similar to your rifle's before the stem presses the bullet straight down. Everything is aligned before any pressure is applied, which keeps runout very low and concentricity very high. That's why it's a longtime favorite among benchrest and precision shooters.
The die comes with the seater base that lifts the primer above the arbor press plate, plus instructions. You'll want an arbor press to run it, and Wilson's own and K&M presses are designed with these dies in mind. A matching sizing die for your 300 WSM brass rounds out the setup.
| UPC | 815145022554 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | S30-WSM |
| Shipping Weight | 1.0 |
You must be logged in to post a review.
Reviews
There are no reviews yet.