Description
The Lee Precision 260 Remington Factory Crimp Die takes the guesswork out of one of the final steps in your reloading process. Instead of relying on a traditional roll crimp, this die uses a collet that squeezes the case mouth into the bullet for a firm, uniform hold. It's a smart addition for anyone loading the 6.5mm .260 Rem for hunting or precision work who wants consistent results round after round.
How the 260 Remington Factory Crimp Die Works
The collet design is what sets this die apart. As the ram comes up, the collet closes around the case neck and forms a crimp into the bullet, even on bullets that don't have a cannelure or crimp groove. A firm crimp means pressure has to build to a higher level before the bullet starts to move, which tends to smooth out your pressure curve and tighten up velocity spreads. It's a straightforward way to get more uniform ammo without chasing exotic components.
Easy Setup With the Lee 260 Rem Crimp Die
Dialing in the crimp is about as simple as it gets. You adjust the die by screw to set the amount of crimp you want, then run your cases through. One of the nicer perks is that trim length isn't critical with this die, so you don't have to obsess over getting every case to an exact measurement before crimping. It's tough to buckle a case the way you can with a conventional roll crimp, which makes it a forgiving tool for newer handloaders and a time saver for experienced ones.
A Note on Fit and Compatibility
This die threads into any standard 7/8-14 reloading press, so it drops right into most single stage and turret setups. Keep in mind this is the collet-style rifle crimp die built from steel, not a carbide design, and the shellholder is sold separately. Pair it with your sizing and seating dies and you've got a complete loading sequence for the .260 Remington.
Key Specifications
- Manufacturer: Lee Precision
- Manufacturer Part Number: 90977
- UPC: 734307909772
- Caliber: 260 Remington
- Die Style: Factory Crimp Die (Collet Style)
- Series: Rifle
- Material: Steel
- Thread: 7/8-14 (fits standard reloading presses)
- Crimp Type: Segmented collet crimp
- Shellholder: Not included
- Shipping Weight: 0.4 lb
What’s Included
- Lee Precision 260 Remington Factory Crimp Die (collet style)
- Storage container
- Instructions
Frequently Asked Questions
Is the Lee 260 Remington Factory Crimp Die a carbide die?
No, this is the collet-style rifle Factory Crimp Die made from steel, and Lee specifically notes it is not carbide. It uses a collet that squeezes the case mouth into the bullet rather than a carbide sizing ring. It still delivers a firm, factory-style crimp for your .260 Rem loads.
Do my bullets need a cannelure or crimp groove to use this die?
No. The collet is powerful enough to form its own crimp, so bullets without a cannelure or crimp groove will still crimp cleanly. Testing has shown that even bullets with no crimp groove can shoot more accurately once they're crimped firmly in place.
Will this die fit my reloading press?
Yes, as long as your press uses the standard 7/8-14 thread, which covers the vast majority of single stage and turret presses. It threads right in alongside your other dies. Just remember the shellholder is sold separately.
Does case trim length matter when using the 260 Remington Factory Crimp Die?
Trim length is not critical with this die, which is one of its best features. Because the collet forms the crimp based on the bullet rather than exact case length, you get consistent crimps even with slight variation in your brass. That makes it a forgiving tool and saves time on the bench.





Reviews
There are no reviews yet.