Description
The Lee Collet Neck Sizer Die takes a different approach than a standard neck sizer. Instead of forcing the neck through a tapered hole and dragging an expander ball back through it, this die uses a collet that squeezes the outside of the case neck against a central mandrel. The result is a precisely aligned neck with minimal runout and no stretching or working of the brass. It sizes the neck only, so there's no case lube to mess with and no stuck cases to deal with.
What the Lee Collet Die Does for Your Brass
When you fire a case, it forms to the chamber of your rifle. Full-length sizing pushes all that back down, but neck sizing keeps that custom fit intact. By only touching the neck, the Collet Die preserves that fire-formed shape, which is why neck-sized cases can last several times longer than full-length sized brass. For a reloader running a bolt gun and chasing consistent shot-to-shot results, that's a real advantage at the bench.
Getting the Most From the .30-06 Collet Neck Sizer
Neck tension comes from the mandrel diameter, not from how hard you lean on the press, so if you want tighter or looser tension down the road, Lee sells replacement mandrels you can swap in. A solid tip that experienced loaders swear by: size the case, back it out an inch, rotate it about an eighth of a turn, and size again. That lands the collet fingers on the high spots of the neck and gives you a rounder, more even result. Go easy on the handle too, since it takes very little force to close the collet, and overdoing it can leave small ridges on the neck.
Keep in mind this is a neck-sizing die, meant for cases fired in the same rifle. It's best suited to bolt-action use rather than autoloaders, pump, or lever guns. Pair it with a full-length or factory crimp die if your loading needs call for it, and you've got a precision-minded setup that's tough to beat for the money.
Key Specifications
- Manufacturer: Lee Precision
- Manufacturer Part Number (MPN): 90960
- UPC: 734307909604
- Caliber: .30-06 Springfield
- Die Type: Collet Neck Sizer
- Die Series: Collet
- Gun Type: Rifle
- Sizing Method: Collet squeezes neck against a precision mandrel
- Case Lube Required: No
- Dies In Set: 1
- Country of Origin: United States
What’s Included
- Lee Collet Neck Sizing Die (.30-06 Springfield)
- Instruction sheet
Frequently Asked Questions
How is the Lee Collet Neck Sizer Die different from a regular neck sizing die?
A standard neck die pushes the neck through a hole and then drags an expander ball back through the inside, which can work the brass and add runout. The Collet Die instead uses a split collet to squeeze the outside of the neck onto a central mandrel, so there's no stretching or drawing of the brass. The inside neck diameter is controlled by the mandrel, which tends to produce straighter necks with less runout.
Does the Lee Collet Die need case lube?
No, it does not. Since the die only sizes the neck and works by compression rather than pulling the case through, you skip the lube step entirely. That also means no stuck cases and no cleanup afterward.
Can I use the .30-06 Collet Neck Sizer for an autoloader or lever gun?
Neck sizing is intended for cases that will be fired in the same rifle, and it's really meant for bolt-action use. It's not recommended for autoloaders, pump, or lever-action guns since those typically need full-length sized brass to chamber and cycle reliably. If you're loading for multiple rifles or a semi-auto, a full-length sizing die is the better call.
How do I get more neck tension with the Lee Collet Die?
Neck tension is set by the diameter of the mandrel, not by how hard you push the press handle. Leaning harder on the handle won't add tension and can actually leave ridges on the neck. To change tension, you'd swap to a smaller-diameter replacement mandrel from Lee, which are sold separately.




Reviews
There are no reviews yet.