Description
The Lee Precision Collet Neck Sizer Die for .270 Winchester takes a different approach than a standard sizing die. Instead of pushing brass through a ring and working the whole case body, it uses a steel collet that squeezes the case neck against a precision mandrel. The result is a neck that's sized evenly from top to bottom with very little runout, and since the body of the case is left alone, your brass stays fire-formed to your rifle's chamber. No case lube required, which means no greasy mess and no cleaning step afterward.
How the Collet Neck Sizer Die Earns Its Keep
Neck sizing only touches the part of the case that needs attention, so your brass gets worked far less than it would with full length sizing. That translates to longer case life and less frequent trimming. Because the neck is pressed against a fixed mandrel rather than drawn through a die, any inconsistency in neck wall thickness gets pushed to the outside, giving you straighter necks and more uniform neck tension round to round. That consistency is what shows up on paper when you're chasing tighter groups.
Getting the Most From Your .270 Win Collet Die
This die is meant for brass fired in your own rifle, and it shines in bolt guns. A popular trick among experienced reloaders is to size, then back the case out about an inch, spin it roughly an eighth of a turn in the shellholder, and size again. That places the collet fingers on fresh spots around the neck for an even rounder result. Setup is simple: run the die down to touch the shellholder, then turn it in a bit further so the collet can close, and apply firm pressure on the press handle rather than letting it cam over. If you ever want more neck tension, you can reduce the mandrel diameter slightly or order a custom one from Lee.
It threads into any standard 7/8-14 press and includes a collet-style decapper, so it punches the spent primer while it sizes. For .270 Win handloaders running a bolt rifle who want accuracy and brass that goes the distance, this is one of the most proven tools in the game.
Key Specifications
- Manufacturer: Lee Precision
- Manufacturer Part Number: 90958
- UPC: 734307909581
- Caliber: .270 Winchester
- Die Type: Collet Neck Sizing Rifle Die
- Die Series: Collet
- Material: Steel
- Thread Size: 7/8-14
- Lubrication Required: No
- Dies In Set: 1
- Recommended For: Bolt-action rifles using brass fired in your own gun
What’s Included
- Steel Collet Neck Sizing Die (.270 Winchester)
- Custom fit plastic storage container
Frequently Asked Questions
Does the Lee Collet Neck Sizer Die need case lube?
No, and that's one of the big draws. The collet squeezes the neck against a mandrel rather than drawing the case through a die, so there's no lube required. That saves you the lubing and cleaning steps and keeps your brass clean.
What brass should I use with this .270 Win collet die?
Use it only on brass that has been fired in your own rifle. Because the die sizes just the neck and leaves the case body fire-formed to your chamber, mixed range brass or cases from other rifles won't fit reliably. Lee does not recommend neck sizing for autoloaders, slide, or lever action guns, so this is really a bolt gun tool.
Can I adjust the neck tension on the Lee Collet Die?
Yes. Neck tension is set by the diameter of the mandrel, so you can carefully reduce the mandrel diameter for more tension or order a custom mandrel from Lee sized to what you want. Many reloaders also size twice, spinning the case a small fraction of a turn between passes, for a rounder neck and slightly more consistent tension.
Will this die work in my press, and does it deprime?
It threads into any standard 7/8-14 reloading press, which covers the vast majority of single stage presses out there. It includes a collet-style decapper, so it punches out the spent primer while it sizes the neck. Set the die down to touch the shellholder, then turn it in a little further so the collet can close properly.





Reviews
There are no reviews yet.