Description
The Lee Carbide Factory Crimp Die for .380 ACP earns a permanent spot on the press for anyone loading this little round in volume. It does two jobs in one pull of the handle: a carbide ring post-sizes the finished cartridge while a separate collet applies a taper crimp dialed in by a simple adjusting screw. Because the .380 headspaces on the case mouth, that taper crimp is the right call for an autoloader round, and this die keeps the mouth sized correctly so your ammo chambers and feeds without the fuss of a round that hangs up.
What the .380 ACP Factory Crimp Die Brings to the Bench
The real draw here is reliability. Post-sizing every finished round means even a slightly fat case or an oversized bullet gets brought back into spec, so your reloads behave like factory ammo in the chamber. A firm, consistent crimp also helps powder burn more uniformly, which tends to tighten up groups and clean up ignition. It is a cheap insurance policy against the one round that would otherwise jam up a range session.
Setting Up Your Lee Carbide Crimp Die
The die threads into any press with standard 7/8"-14 threads, so it drops right into a single-stage or turret setup. The crimp is adjustable by screw, and it is built so you cannot squeeze the case mouth down far enough to ruin headspacing. One thing worth noting: trim length is not critical with this design, which saves you the trimming and chamfering step that other crimping methods demand.
Keep in mind this is a single die, not a full set, and you will need a .380 shell holder, which is sold separately. It also pairs perfectly as the finishing die alongside Lee's deluxe 4-die set if you already run their gear. For folks loading .380 for plinking, practice, or carry rounds they want to trust, this is one of the most popular upgrades you can make to a straight-wall pistol loading setup.
Key Specifications
- Manufacturer: Lee Precision
- Manufacturer Part Number: 90867
- UPC: 734307908676
- Caliber: .380 ACP / .380 Auto
- Die Style: Carbide Factory Crimp Die
- Crimp Type: Taper crimp (autoloader)
- Material: Steel body with internal carbide ring
- Thread Size: 7/8"-14 (standard)
- Number of Dies: 1
- Overall Length: 4.8 in
- Country of Origin: United States
What’s Included
- Lee Carbide Factory Crimp Die for .380 ACP (single die)
- Instruction sheet
Frequently Asked Questions
Does the Lee Factory Crimp Die for .380 ACP apply a roll crimp or a taper crimp?
For the .380 ACP it applies a taper crimp, which is the correct crimp for a rimless autoloader cartridge that headspaces on the case mouth. The design also prevents you from crimping the mouth so tight that it affects headspacing. Lee reserves roll crimps for their revolver dies.
Do I need lube when using this carbide die?
No. The internal carbide ring post-sizes the finished round without case lube, so you skip the lubing and the cleanup that goes with it. That is one of the nicer perks of running carbide on straight-wall pistol brass.
Is a shell holder included with the .380 ACP Factory Crimp Die?
No, a shell holder is sold separately. You will need the correct .380 shell holder for your press, and the die itself threads into any press with standard 7/8"-14 threads.
Can I use this die on its own or do I need a full die set?
This is a single finishing die that you add as a separate crimping station after sizing, priming, charging, and seating. Many loaders run it alongside a standard 3-die set to post-size and crimp in one final step. It is also the same crimp die included in Lee's deluxe 4-die set for .380 Auto.





Reviews
There are no reviews yet.