Description
The Lee Carbide Factory Crimp Die for .45 Long Colt takes one of the fussier steps in handgun reloading and makes it just about foolproof. It applies a firm roll crimp while a carbide ring inside the die post-sizes the finished round, so what comes out drops into your cylinder or chamber with factory-like reliability. A simple adjusting screw lets you dial in exactly how much crimp you want, and because case trim length isn't critical with this design, you can skip a lot of the measuring and chamfering that other crimp methods demand.
That firm, even crimp does more than just hold the bullet in place. A good crimp gives you a more uniform pressure curve, which matters a lot with the slow-burning magnum powders common in heavy .45 Colt loads. Better ignition means better consistency downrange, and it helps keep bullets from walking under recoil, something revolver shooters loading stout rounds know all too well.
What the Lee Carbide Factory Crimp Die Brings to Your Bench
This is a single crimp die, not a full die set, so it's meant to round out your existing .45 Colt setup or replace a crimp step you're not happy with. The body is steel with the carbide sizing ring built in, and it uses the standard 7/8-14 thread that fits Lee, Dillon, Hornady, Lyman, RCBS, and just about every modern press out there.
Loading .45 Colt and .454 Casull With One Die
One of the handier things about this die is its range. It's set up for .45 Colt (Long Colt) and also handles .454 Casull, so if you shoot both out of a convertible revolver or a heavy-frame single action, you've got your crimp covered with a single tool. Set it once for your load, tighten the lock ring, and you're good to run batch after batch with the same clean result every time.
Key Specifications
- Manufacturer: Lee Precision
- Manufacturer Part Number: 90865
- UPC: 734307908652
- Caliber: .45 Long Colt / .454 Casull
- Die Type: Carbide Factory Crimp Die
- Crimp Style: Roll Crimp
- Number of Dies: 1
- Thread Size: 7/8-14
- Body Material: Steel with internal carbide ring
- Shellholder Included: No
- Length: 4.75 in
- Dimensions: 1.60 x 1.70 x 4.75 in
What’s Included
- Lee Carbide Factory Crimp Die (single die)
- Storage box
- Instructions
Frequently Asked Questions
Does the Lee Carbide Factory Crimp Die come with a shellholder?
No, this is a standalone crimp die and does not include a shellholder. You'll need the correct shellholder for .45 Colt, which you likely already have if you're loading the cartridge. The die does ship in its own storage box with instructions.
Will this die fit my press?
Yes, it uses the standard 7/8-14 thread, so it threads right into Lee, Dillon, Hornady, Lyman, RCBS, and most other modern presses. If your press takes conventional dies, this one will drop in without any trouble.
What kind of crimp does it put on .45 Long Colt?
It applies a roll crimp, which is the right style for .45 Colt and .454 Casull since both headspace on the case rim. The adjusting screw lets you set exactly how much crimp you want, and a carbide ring post-sizes the round as it crimps so it chambers freely.
Can I use this die for .454 Casull too?
Yes, this same die is set up to handle both .45 Colt (Long Colt) and .454 Casull. That makes it a convenient pick if you shoot both cartridges, especially out of a convertible or heavy-frame revolver.




Reviews
There are no reviews yet.