Description
The Lee Factory Crimp Die for .270 Winchester is the die a lot of handloaders reach for when they want their rounds held together right. Instead of the roll crimp you get from a standard seating die, this one uses a collet that squeezes the case mouth inward from four sides. That means you get a square, even crimp without the case buckling that trips people up with roll crimp setups. It threads into any press that takes standard 7/8-14 dies, so it drops right into most single stage and turret presses.
What the Lee .270 Winchester Crimp Die Does Differently
The real draw here is consistency. A firm, uniform crimp forces pressure to build to a higher level before the bullet starts moving, and that higher start pressure smooths out your pressure curve and tightens up velocity variation from shot to shot. For a flat-shooting cartridge like the .270 that a lot of folks run on deer and antelope out to real distance, trimming down your velocity spread pays off on paper and in the field. One of the handier perks is that trim length isn't critical with this die, so you spend less time fussing over case length before the crimp step.
Running Bullets Without a Crimp Groove
This is where the Factory Crimp Die earns its keep. The collet is strong enough that it will form its own crimp into the jacket, so you're not limited to bullets with a factory cannelure. Plenty of match and hunting bullets for the .270 don't have a crimp groove, and reloaders report cleaner, more accurate results after adding a light crimp with this die. It's a popular choice for lead-free bullets too, where a touch of crimp can help pull out better groups.
Setup and Adjustment
Setup is quick. You thread the die in and use the adjustment to dial anywhere from a light touch to a heavier crimp depending on your load and your rifle. The die body is steel and ships in a plastic storage box to keep it protected on the bench. Keep in mind the shell holder is sold separately, so grab one in the correct size if you don't already have it.
Key Specifications
- Manufacturer: Lee Precision
- Manufacturer Part Number: 90820
- UPC: 734307908201
- Caliber: .270 Winchester
- Product Type: Factory Crimp Rifle Die
- Crimp Style: Collet-style rifle crimp
- Material: Steel
- Thread Size: 7/8-14
- Dies In Set: 1
- Length: 4.7 in
- Shell Holder Included: No
- Storage Box: Included
- Country of Origin: United States
What’s Included
- Lee Factory Crimp Die .270 Winchester (90820)
- Plastic storage box
- Instructions
Frequently Asked Questions
Do my .270 bullets need a crimp groove to use the Lee Factory Crimp Die?
No, they don't. The collet on this die is strong enough to form its own crimp directly into the bullet jacket, so you can use it with bullets that have no cannelure. That makes it a good option for match bullets and lead-free bullets that aren't cut for a traditional roll crimp.
Will the Lee Factory Crimp Die fit my reloading press?
It uses the standard 7/8-14 thread, so it threads into virtually any single stage, turret, or progressive press that accepts common dies. You will need the correct shell holder for the .270 Winchester case, which is not included with this die.
How is this different from the crimp built into a seating die?
A standard seating die applies a roll crimp, which can buckle the case if your setup or trim length is off. The Factory Crimp Die uses a collet that squeezes the case mouth inward evenly, so it's far harder to buckle a case and trim length isn't critical. The result is a more uniform crimp and more consistent start pressure.
Can I adjust how much crimp this die applies?
Yes. The die adjusts from a light crimp all the way up to a heavier crimp, so you can tune it to your specific load and rifle. Many reloaders start light and work up until they find the crimp that gives them the best groups.




Reviews
There are no reviews yet.