$37.99
5 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The Barnes TSX in .224 diameter is the bullet that put solid copper hunting projectiles on the map. At 50 grains with a flat base, this is one of the lighter and more twist-friendly options in the lineup, which is a big reason it has such a loyal following among folks running .223 Rem, .22-250, and other fast .22 centerfires. It carries a sectional density of 0.142 and a G1 ballistic coefficient of 0.197, with an overall length right around 0.736 inches.
This is a 100 percent copper design with no lead core to come apart on impact. On game it opens up into four razor-sharp petals and tends to drive straight through, often leaving an exit. Because there is no lead to shed, the TSX holds nearly all of its original weight, which translates to deep penetration and consistent wound channels. The multiple grooves cut into the shank are more than looks. They give the copper somewhere to flow under pressure, which cuts down on fouling and lets you push the bullet to higher velocities when your load data allows.
One thing experienced reloaders will tell you about Barnes copper bullets is that seating depth matters. Barnes suggests starting around 0.030 to 0.070 inches off the lands and working from there, since these bullets tend to reward careful load development. Twist rate is worth a look too. Copper bullets run longer than lead-core bullets of the same weight, so this 50-grain is a smart pick for slower 1:12 and 1:14 barrels that struggle to stabilize the heavier 53 and 55 grain options.
Shooters have taken whitetail, mule deer, antelope, hogs, and plenty of coyotes with this exact bullet, especially out of .223 and .22-250. At typical .22 centerfire velocities it does its job cleanly, and many report pass-through performance and short recovery distances. If you handload for a .22 and want a tough, accurate hunting projectile, the 50 gr TSX is a benchmark worth building a load around.
Because the all-copper TSX runs longer than a lead-core bullet of the same weight, twist rate matters. The 50 grain is one of the more forgiving options and many reloaders stabilize it in 1:12 and even 1:14 barrels like those found on a lot of .22-250 rifles. Faster twists such as 1:7 through 1:9 on most .223 rifles will handle it easily. As always, your best bet is to shoot your specific rifle and confirm groups.
Yes. Hunters have used this bullet successfully on whitetail, mule deer, antelope, and hogs, especially out of .223 Rem and .22-250. Its all-copper build holds together and penetrates deep, often producing an exit wound and short recovery distances at typical .22 centerfire velocities.
Barnes recommends starting with the bullet seated about 0.030 to 0.070 inches off the lands and working your load from there. Copper bullets like the TSX tend to be sensitive to seating depth, so taking the time to test a few increments usually pays off in accuracy. Always start low and work up using published load data.
Those rings are an engineered feature, not cosmetic. They give the copper a place to flow under pressure as the bullet travels down the bore, which reduces fouling and pressure. That also lets the bullet be loaded to higher velocities and can help smooth out barrel harmonics for better accuracy.
| UPC | 716876224401 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 30174 |
| Caliber/Gauge | .22 Caliber |
| Grains | 50 |
| Quantity | 50 |
| Shipping Weight | 0.42 |
You must be logged in to post a review.
Reviews
There are no reviews yet.