Description
The Redding Series A Taper Crimp Die (MPN 85189) handles the final step of your .45 ACP and .45 Auto Rim handloads with a clean, even taper crimp. These cartridges headspace on the case mouth, which means a roll crimp can cause feeding and chambering headaches. A taper crimp solves that by gently squeezing the case mouth tighter and tighter against the bullet, holding it firmly without buckling the brass or changing your cartridge overall length.
Why the Series A Taper Crimp Die Earns a Spot on Your Bench
Roll crimps work great on revolver rounds with a cannelure, but on rimless auto-pistol brass they tend to do more harm than good. This die applies a long, gradual taper that works the same every time you run the handle. The long taper also makes it adaptable to a range of chamber configurations, so your loaded rounds drop in and feed the way they should. If you've been chasing inconsistent crimps or the occasional round that won't seat right, a dedicated crimp die like this one tightens up your whole process.
What the 85189 Die Is Built From
Redding machines this die from high-grade steel held to tight tolerances, so adjustments stay repeatable load after load. It threads into any standard 7/8-14 reloading press, so it drops right into a single-stage, turret, or progressive setup without fuss. The goal here is uniformity, giving you rounds that look the same and shoot the same.
Getting the Most Out of Your Taper Crimp
This is a single-stage finishing die, meant to crimp separately from seating so you get full control over both steps. Back the die off, run a loaded dummy round up, then sneak the crimp in a little at a time until the case mouth just kisses the bullet. You're looking to remove the flare and add a touch of grip, not crush the brass. Done right, you get rounds that feed smooth and group tight, which is really the whole point of loading your own.
Key Specifications
- Manufacturer: Redding
- Product Line: Series A
- Die Type: Taper Crimp Die
- Cartridge: .45 ACP / .45 Auto Rim
- Material: High-grade steel
- Thread Size: 7/8-14
- Quantity: 1 die
- Manufacturer Part Number: 85189
- UPC: 611760851896
- Shipping Weight: 0.425 lbs
- Country of Origin: United States
What’s Included
- Redding Series A Taper Crimp Die (.45 ACP / .45 Auto Rim)
- Instruction sheet
Frequently Asked Questions
What cartridges does the Redding Series A Taper Crimp Die 85189 work with?
This die is set up for .45 ACP and .45 Auto Rim. Both cartridges headspace on the case mouth, which is exactly the situation a taper crimp is designed for. If you load those rounds, this is the crimp die you want.
Why use a taper crimp instead of a roll crimp on .45 ACP?
A roll crimp rolls the case mouth into a cannelure, which is fine for revolver rounds but causes trouble on rimless auto brass that headspaces on the mouth. A taper crimp gently squeezes the case mouth tighter against the bullet to hold it in place without rolling the edge over. It also doesn't change your cartridge overall length, so your loads stay consistent and feed reliably.
Will the Redding taper crimp die fit my press?
Yes. It uses the standard 7/8-14 thread, so it works in single-stage, turret, and progressive presses from the major brands. Just thread it in like any other die and dial in your crimp.
Is this a complete die set or a single die?
This is a single taper crimp die, not a full reloading set. It's meant to handle the crimping step on its own, which lets you seat and crimp separately for better control. You'll still need your sizing and seating dies to complete the load.





Reviews
There are no reviews yet.