Description
If you're loading .25-06 Remington, this Redding Series A two-die set covers the two jobs that matter most: bringing fired brass back into spec and seating bullets where you want them. The full-length sizing die works the entire case body and bumps the shoulder back so your reloads chamber smoothly in any .25-06 you run them through. The standard seater handles bullet seating with a built-in crimp ring, so you can crimp or not depending on how you load.
What Sets the Redding .25-06 Die Set Apart
Redding has been building reloading gear in New York for decades, and the fit and finish show it. The full-length sizing die comes with a decapping rod assembly, a neck expander button, and a decapping pin, so it knocks out spent primers and sets neck tension in one stroke. The seating die uses a bullet guide and a threaded seating plug, which means you dial seating depth right at the die and keep your rounds consistent from the first to the last.
Running the 80120 Set on Your Press
Both dies use the standard 7/8"-14 thread, so they'll thread into any common single-stage or turret press without an adapter. This set works for the .25-06, a flat-shooting quarter-bore that's a longtime favorite for deer, antelope, and open-country varmints. Dialed-in handloads let you tune that cartridge to whatever bullet weight your rifle likes best.
A Few Things Worth Knowing Before Setup
The shellholder is not included with this set, so grab a #1 shellholder for the .25-06 if you don't already have one on the bench. The dies ship in a plastic storage case with a spare decapping pin and a wrench for the lock rings, which keeps everything organized between sessions. For most handloaders, this is a straightforward, well-made set that just works trip after trip.
Key Specifications
- Manufacturer: Redding
- Caliber: .25-06 Remington
- Series: Series A Conventional
- Die Type: Full Length 2-Die Set
- Dies Included: Full Length Sizing Die, Standard Bullet Seating Die
- Thread Size: 7/8"-14
- Material: Steel
- Shellholder: #1 (sold separately)
- Bullet Diameter: 0.257"
- Country of Origin: USA
- Manufacturer Part Number: 80120
- UPC: 611760801204
What’s Included
- Full length sizing die with decapping rod assembly, neck expander button, and decapping pin
- Standard bullet seating die with seating plug and built-in crimp ring
- Plastic storage case
- Spare decapping pin
- Allen wrench for lock rings
Frequently Asked Questions
Does the Redding .25-06 die set come with a shellholder?
No, the shellholder is sold separately. The .25-06 Remington uses a standard #1 shellholder, so pick one up if it isn't already on your bench. That same shellholder covers several other cartridges in the same case-head family.
Will these dies fit my reloading press?
Yes. Both dies use the standard 7/8"-14 thread, which is the common size for single-stage and turret presses. They'll thread right in without any adapter.
Can I crimp with the seating die in this set?
The standard seating die has a built-in crimp ring, so you can apply a roll crimp if your load calls for it. You can also set it up to seat without crimping, which is how a lot of bolt-gun handloaders run it. Seating depth is adjusted by threading the seating plug in or out.
What does the full length sizing die actually do?
It resizes the entire case body and bumps the shoulder back to reset headspace, so your reloads chamber easily in any .25-06 rifle. It also decaps the spent primer and sets neck tension in the same stroke thanks to the decapping rod and expander button. This is the go-to choice when you want brass that feeds reliably across multiple rifles or after repeated firings.





Reviews
There are no reviews yet.