Description
If you neck size your 6mm Dasher brass to squeeze out every last bit of accuracy, you've probably run into cases that slowly get stubborn to chamber after a handful of firings. That's exactly the job this die was built for. The Redding 6mm Dasher Body Die full length resizes the case body and sets the shoulder back the small amount needed for smooth chambering, all without touching the neck. It leaves your established neck tension right where you want it.
Redding has been machining body dies for the benchrest crowd for years, long before they ever made it into the catalog. With the arrival of their bushing-style neck sizing die sets, the body die became the natural companion piece. It threads into any standard 7/8-14 reloading press and runs in your existing setup without fuss.
How the 6mm Dasher Body Die Fits Your Workflow
This die carries no internal parts. There's no decapping rod and no expander, because its only job is the body and the shoulder. The typical approach is to neck size until a case starts showing resistance when you close the bolt, then run it through the body die to bump the shoulder back a couple thousandths and bring it back into spec. The Dasher headspaces off its 30 degree shoulder, so a headspace comparator is worth having on the bench to keep your bump honest and your brass lasting as long as possible.
Built From Hardened Steel for the Long Haul
Like the rest of the Redding lineup, this one is machined from heat-treated steel in the USA and finished to hold tight tolerances firing after firing. It ships in a protective plastic storage case so it stays clean and protected between loading sessions. For the precision reloader who wants to preserve neck tension while keeping body dimensions in check, it's a straightforward, dependable addition to the bench.
Key Specifications
- Manufacturer: Redding
- Cartridge: 6mm Dasher
- Die Type: Body Die (Full Length Body Sizer)
- Bullet Diameter: 0.243 in
- Material: Heat-Treated Steel
- Thread: 7/8-14 (standard press)
- Internal Parts: None (sizes body and shoulder only)
- Country of Origin: United States
- Manufacturer Part Number: 75648
- UPC: 611760756481
- Shipping Weight: 0.415 lb
What’s Included
- Redding 6mm Dasher Body Die (1)
- Plastic storage case
Frequently Asked Questions
What does the Redding 6mm Dasher Body Die do that a neck sizing die doesn't?
The body die resizes the case body and bumps the shoulder back for proper chambering, while a neck die only works the neck. Using the two together lets you control neck tension separately from body and shoulder dimensions. That's why precision handloaders pair the body die with a bushing-style neck die as their complete setup.
Does this die size or touch the case neck at all?
No. It is made without internal parts and leaves the neck completely alone, so your established neck tension stays exactly where you set it. Its work is limited to the case body and the shoulder bump.
When should I reach for the 6mm Dasher Body Die?
It's meant for cases that have become harder to chamber after repeated firing and neck sizing. Once a case starts resisting the bolt, a pass through the body die bumps the shoulder back a couple thousandths and brings it back into spec. A headspace comparator helps you bump only the minimum needed to keep brass life long.
Will this die work in my standard reloading press?
Yes. It uses the standard 7/8-14 thread and runs in any common single-stage or turret press. No special hardware is required beyond your usual shellholder for the 6mm Dasher.





Reviews
There are no reviews yet.