Description
Neck tension is one of those little details that separates good handloads from great ones, and this .329-inch Hornady Match Grade bushing gives you direct control over it. Drop it into a Hornady Match Grade sizing die and the bushing resizes the case neck to a specific dimension rather than squeezing everything down to SAAMI minimum like a standard die would. That means you're only sizing the neck as much as your brass and chamber actually call for, which keeps the brass alive longer and helps your rounds chamber with consistent, repeatable tension.
How the .329 Hornady Bushing Works in Your Press
The bushing is self-centering inside the die body, so it floats and aligns itself to the case neck during the stroke. That alignment is what keeps runout down and helps produce straighter loaded rounds. It's a polished steel bushing measured by inside diameter, and the .329 size falls in Hornady's 30 caliber lineup. Hornady offers these in .001-inch and .002-inch increments across the range, so you can fine-tune up or down if your brass springs back more or less than expected.
Picking the Right Bushing Size for Your Brass
A good starting point is to measure the neck diameter of a loaded or dummy round that fits your chamber well, then subtract about .001 inch from that number. Choose a bushing at or just under that dimension. Keep in mind brass type matters here. Some brass, like Lapua, tends to spring back around .002 inch, so many reloaders keep a bushing one size above and one below on hand unless they're turning necks. The nice thing is these swap out in seconds, so experimenting to find your sweet spot is painless.
This bushing fits both Hornady Match Grade neck sizing and full length dies, and it's made in the USA. If you're chasing tighter groups and want your necks sized exactly the way you want them, this is the part that gets you there.
Key Specifications
- Manufacturer: Hornady
- Manufacturer Part Number: 594329
- UPC: 090255593297
- Bushing Inside Diameter: .329 inch
- Caliber Range: 30 Caliber
- Type: Neck Size Bushing
- Design: Self-centering, interchangeable
- Material/Finish: Polished steel
- Compatibility: Hornady Match Grade neck and full length dies
- Quantity: 1
- Country of Origin: Made in USA
What’s Included
- One Hornady Match Grade .329-inch neck size bushing
Frequently Asked Questions
What dies does the Hornady Match Grade .329 bushing fit?
It's designed for Hornady Match Grade dies, and it works in both the neck sizing and full length versions. The bushing is sold separately since Match Grade dies don't come with one included. It self-centers inside the die body once installed.
How do I know if .329 is the right bushing size for me?
Measure the neck diameter of a loaded or dummy round that fits your chamber, then subtract about .001 inch and pick a bushing at or just under that number. Brass type plays a role too, since some brass springs back around .002 inch after sizing. Many reloaders keep the size above and below on hand to dial things in.
What's the benefit of a bushing over a standard sizing die?
A standard die sizes the neck down to SAAMI minimum, which often works the brass more than necessary. This bushing lets you size the neck only as much as your chamber and brass need, which extends case life and gives you consistent neck tension. That consistency is what helps tighten groups at the range.
Is the .329 bushing self-centering?
Yes. It floats inside the die body and aligns itself to the case neck during the sizing stroke. That self-centering action helps reduce runout and produce straighter loaded rounds.




Reviews
There are no reviews yet.