Description
The Hornady Match Grade Bushing in .278 inch is a single interchangeable insert that drops into Hornady Match Grade Bushing Dies and gives you full control over how much your case necks get sized. Instead of relying on a fixed internal diameter and an expander ball that sizes down then pulls back open, a bushing like this one sizes the neck straight to the diameter you pick. Less work on the brass, more consistency where it counts.
The design is self-centering, so the bushing floats and aligns with the case neck as it enters the die. That keeps runout down and helps every round come out the same. These bushings are offered in .001 inch increments across the lineup, and this one carries a .278 outside diameter, which falls in Hornady's .25 caliber range. Pairing the right bushing with your brass is the whole point of a system like this.
Picking the Right .278 Match Grade Bushing for Your Load
The most reliable way to land on the correct bushing is to take a loaded round, measure the outside diameter at the neck with a micrometer, and subtract about .001 to .002 inch for the spring-back and the neck tension you're after. If you shoot a bolt gun and want to fine tune, a lot of folks keep a bushing one size up and one size down from their target so they can experiment without re-ordering. Thicker or uneven neck walls can call for going a touch smaller and finishing with a mandrel or expander.
Why a Bushing Beats Standard Sizing
The payoff with the Hornady .278 Match Grade Bushing is brass life and repeatability. Because it only sizes the neck down to the diameter you choose, the brass gets worked less each cycle, which means more firings before necks start to split and more uniform tension from round to round. For precision and long-range handloaders, that tighter control at the press tends to show up as tighter groups on paper. Keep in mind this is a single bushing, not a complete die, so you'll need a Hornady Match Grade Bushing Die to run it.
Key Specifications
- Brand: Hornady
- Diameter: .278 in
- Caliber Range: .25 Cal.
- Bushing Type: Self-centering, interchangeable neck size bushing
- Sizing Increments: .001 in across the lineup
- Quantity: 1 bushing
- Compatibility: Hornady Match Grade Bushing Dies
- Manufacturer Part Number: 594278
- UPC: 090255592788
- Shipping Weight: 0.025 lb
What’s Included
- 1 Hornady Match Grade Bushing, .278 in diameter
Frequently Asked Questions
What does the .278 Hornady Match Grade Bushing fit?
This bushing is made to work inside Hornady Match Grade Bushing Dies, which come in full-length sizing and shoulder bump neck sizing styles. You install the bushing in the die and it handles the neck sizing portion of the process. On its own it is just the insert, so you'll need the matching die to use it.
How do I know if .278 is the right bushing size for my load?
Take a loaded round, measure the outside diameter of the case neck with a micrometer, and subtract roughly .001 to .002 inch for spring-back and your desired neck tension. If that math lands around .278, this is your bushing. Many handloaders keep a size up and a size down so they can fine tune neck tension at the bench.
Why use a bushing instead of a standard sizing die?
A standard die uses a fixed diameter and an expander ball that sizes the neck down then pulls it back open, which works the brass harder. A bushing sizes the neck straight to the diameter you choose, so the brass gets worked less and lasts longer. That tighter, more consistent neck tension is what helps precision shooters get more uniform groups.
Is this a self-centering bushing?
Yes. The Hornady Match Grade Bushing is self-centering, so it floats and aligns itself with the case neck as the case enters the die. That design helps keep runout low and keeps your sizing consistent from round to round.





Reviews
There are no reviews yet.