Description
The RCBS Little Dandy Powder Rotor #14 is one of the interchangeable fixed-charge rotors built for the Little Dandy powder measure, and it's a favorite among folks loading pistol and small rifle cartridges. Instead of dialing in a micrometer every session, you pop in the rotor sized for your load and it throws the same volume of powder every single pull. It's machined from steel for a tight fit inside the measure body, which is what keeps those volumetric charges repeatable throw after throw.
Where the #14 Rotor Fits In
RCBS makes this rotor family in dozens of numbered sizes, each one tuned to a different powder volume. The #14 lands in the range that covers a lot of common handgun and smaller rifle charges, but the actual grain weight depends entirely on which powder you're running. That's why RCBS publishes a rotor charge chart matching each numbered rotor to popular powders. Print it out, find your powder, and it gives you a solid starting point.
Getting Consistent Throws With the Little Dandy Rotor
The beauty of a fixed rotor is that once you verify the charge, there's nothing left to drift. A good habit is to cycle the rotor ten to twenty times to settle the powder, then weigh several throws on a scale before you commit. Reloaders who've used these for years tend to find them spot on to the stated charge, often running a touch under rather than over, which is the safe direction to lean. Always confirm against published load data and your own scale.
Hand-Held or Bench-Mounted
You can run the Little Dandy right in your hand, resting the drop tube on the case mouth and rotating the rotor to dispense, which makes quick work of a loading block full of cases. If you'd rather keep it anchored, it mounts to an RCBS powder measure stand on your bench. Either way, the #14 rotor is the simple, no-fuss piece that keeps your charges honest once you've dialed in your load.
Key Specifications
- Manufacturer: RCBS
- Manufacturer Part Number: 86014
- Model Number: 86014
- UPC: 076683860149
- Rotor Size: #14
- Type: Fixed Charge Interchangeable Powder Rotor
- Application: Pistol / Small Rifle
- Material: Steel / Metal
- Finish: Gray
- Function: Volumetric Powder Measuring
- Compatibility: RCBS Little Dandy Powder Measure
- Quantity: 1 Rotor
What’s Included
- RCBS Little Dandy Powder Rotor #14 (Pistol/Small Rifle)
Frequently Asked Questions
What does the RCBS Little Dandy Powder Rotor #14 fit?
This rotor is made specifically for the RCBS Little Dandy powder measure. It drops right into the measure body and swaps out with any of the other numbered rotors in the series. It is not a standalone tool, so you'll need the Little Dandy measure to use it.
How many grains does the #14 rotor throw?
There's no single grain number because the rotor meters by volume, not weight. The actual charge depends on which powder you're running, so a denser powder will weigh more than a fluffier one from the same rotor. RCBS publishes a rotor charge chart that lists the nominal charge for each numbered rotor across popular powders, and you should always verify the throw on your own scale.
Do I need to adjust the Little Dandy rotor after installing it?
No, that's the whole point of a fixed-charge rotor. Once you swap it in there's no micrometer to set and no readjustment needed. A good practice is to cycle it ten to twenty times to condition the throw, then weigh a few charges to confirm before you load.
Can I use the Little Dandy with the #14 rotor by hand?
Yes. You can hold the measure in one hand, rest the drop tube on the case mouth, and rotate to dispense, which is fast when you've got a loading block full of cases. If you prefer, it also mounts to an RCBS powder measure stand so it stays put on your bench.




Reviews
There are no reviews yet.