Description
If you shoot a lot of .223 and dread chasing case length every time you reload, the RCBS X Die Full Length Sizer is built to end that chore. This single full-length sizing die does the job of a standard FL sizer while adding RCBS's patented X mandrel, which features an expander ball and decapping pin attached to one spindle. After an initial trim of about .020 inch off maximum case length, the mandrel limits how far your brass can grow, so repeated trimming becomes a thing of the past.
How the .223 X Die Sizer Controls Case Growth
The secret is the close tolerance between the mandrel and the die's neck wall. As the case mouth contacts the mandrel during sizing, the growth that normally pushes brass forward gets reduced rather than letting the neck wall thicken. Cases run through the X Die grow a few thousandths at first, then settle in below maximum case length and hold steady, with no real loss of accuracy or case life. It full-length sizes the body slightly smaller in diameter than some standard dies, which helps feeding in semi-auto and other hard-working actions.
Setting Up the RCBS X Die Full Length Sizer
The one-time prep matters. You full-length resize, trim your lot to spec, then set the die and mandrel per the instructions before running the brass again. From there you just size as normal and let the cases stabilize. Setup follows the usual RCBS routine: raise the ram, screw the die down to the shell holder, back off, then turn in another eighth to quarter turn for proper cam-over to remove press flex. Keep in mind brass still work-hardens with use, so stay on your normal annealing schedule.
This is a smart pick for high-volume .223 reloaders feeding AR platforms, bolt guns, and other semi-auto, pump, slide, and select lever rifles. Machined from steel and made in the USA, it drops right into your existing single-stage or progressive setup. If you already own a seater die for .223, this sizer is all you need to add the X system to your bench.
Key Specifications
- Brand: RCBS
- Cartridge: .223 Remington
- Die Type: X Die Full Length Sizer
- Sold As: Single sizing die
- Material: Steel
- Mandrel: Expander ball and decapping pin attached
- Initial Trim: About .020 inch off maximum case length
- Country of Origin: United States
- Manufacturer Part Number: 37109
- UPC: 076683371096
- Shipping Weight: 0.7 lbs
What’s Included
- RCBS X Die Full Length Sizer Die for .223 Remington (single die)
Frequently Asked Questions
Do I still have to trim brass with the RCBS X Die Full Length Sizer?
You trim once at the start. The instructions call for a full-length resize and an initial trim of roughly .020 inch off maximum case length, then you set up the X Die and size again. After that the mandrel controls growth, so repeated trimming for that lot of brass is rarely needed.
Is this a complete die set or just the sizer?
This is the single X Die Full Length Sizer only, not a set. If you already own a .223 seater die, this sizer is all you need to add the X system to your bench. Reloaders starting fresh will want to pair it with a seater die.
Will the RCBS X Die .223 work for AR-15 and other semi-auto brass?
Yes. It is designed for ammunition used in semi-automatic, pump, slide, and select lever-action firearms, and it sizes the case body slightly smaller in diameter than some standard dies to help reliable feeding. It works well for high-volume .223 and 5.56 brass shooters.
How does the mandrel keep cases from growing too long?
As the case mouth contacts the mandrel during sizing, the growth that would normally push brass forward is reduced instead of thickening the neck wall. Cases grow a few thousandths at first, then stabilize below maximum length and hold there without hurting accuracy or case life.




Reviews
There are no reviews yet.