Description
The .40-70 Sharps Straight is a piece of American shooting history, and if you run an original or reproduction rifle chambered for it, you already know that factory ammo is scarce and handloading is the way to keep it fed. This RCBS Legacy 3-Die Roll Crimp Set is purpose-built for that job. It's one of the few die sets made to support these legendary metallic black powder cartridges, giving the folks who shoot them a proper tool for the bench.
What the RCBS Legacy .40-70 Sharps Straight Set Does
The set covers the full reloading cycle in three steps. The steel sizer die brings the case back to spec and de-primes it in one stroke. The expander die opens the case mouth to the correct diameter and adds a touch of flare, or belling, so lead bullets seat without shaving. The seater die then presses the bullet to depth and applies a roll crimp, which locks everything in place and is the right crimp style for the heavier bullets these cartridges run. The set is dialed in for .408 to .409 inch bullets, which is what you'll be loading for Shiloh, C. Sharps, and other rifles made in this caliber.
Loading Lead Bullets with the RCBS 19204 Die Set
These are standard 7/8-14 thread dies, so they thread right into any common single-stage press. A quick note worth knowing before you get started: the sizer die is steel, not carbide, so you'll want to lube your brass before running it through. That's normal for a cartridge of this size, and a case lube pad takes care of it in seconds. The roll crimp and expander setup is built around cast lead bullet loads, which is exactly what the Cowboy Action and single-shot rifle crowd is shooting.
RCBS has been making reloading gear in America since 1943, and every die is hand inspected before it leaves the factory. For a cartridge this specialized, having a quality die set made specifically for it is a real advantage.
Key Specifications
- Manufacturer: RCBS
- Manufacturer Part Number: 19204
- UPC: 076683192042
- Series: Legacy
- Caliber: .40-70 Sharps Straight
- Bullet Diameter: .408-.409 inch
- Set Type: 3-Die Roll Crimp Set
- Sizer Die Material: Steel (non-carbide, case lube required)
- Die Thread: 7/8-14
- Crimp Style: Roll Crimp
- Intended Use: Straight-wall black powder cartridge, lead bullet loads
- Country of Origin: United States
- Shipping Weight: 1.9 lbs
What’s Included
- Steel sizer die with decapping unit
- Expander die
- Seater die with roll crimp
Frequently Asked Questions
Does the RCBS Legacy .40-70 Sharps Straight set include a shell holder?
No, the shell holder is sold separately. RCBS does not include shell holders with their die sets, so you'll need to pick up the correct RCBS shell holder for .40-70 Sharps Straight to complete your setup. It's a small, inexpensive piece but necessary to run the dies.
Do I need to lube my brass with this die set?
Yes. The sizer die is steel rather than carbide, so you should lubricate your cases before sizing them. A case lube pad or spray handles it quickly, and skipping this step is the most common cause of stuck brass.
What bullet diameter does this die set load?
This set is set up for .408 to .409 inch bullets, which is the correct diameter for .40-70 Sharps Straight. It works with rifles from Shiloh, C. Sharps, and other makers currently producing guns in this caliber.
Will these dies fit my reloading press?
Yes. These are standard 7/8-14 thread dies, which is the common sizing used by virtually all single-stage and turret presses. They'll thread right in with no adapters needed.



Reviews
There are no reviews yet.