Description
Every reloader eventually loads a round that needs to come apart, whether it's a mistaken charge, a bad seating depth, or a batch you want to break down for components. The RCBS Bullet Puller Collet in .44 Cal / 11mm is the piece that makes that job clean. It's a caliber-specific insert for the RCBS Standard Bullet Puller, machined from steel to grab the bullet securely while leaving the projectile and the case ready to use again.
The way it works mirrors a draw collet on a lathe. As the case is drawn away by the press ram, the collet tightens down on the bullet and locks it in place, so the bullet slides free without getting scratched, deformed, or flattened at the tip. That matters when you're pulling jacketed bullets you plan to reseat, since a damaged tip or a scored jacket usually means the bullet goes in the scrap bin. Reloaders consistently point out that it pulls bullets with little effort and leaves them clean enough to load again.
What the .44 Collet Handles
This 9435 collet is sized for .430 diameter bullets, which covers the common .44-class rounds you're most likely to be breaking down. Think .44 Remington Magnum, .44 Special, and .444 Marlin. If you load any of those and want a mechanical pulling solution instead of beating an inertia hammer on the floor, this is the insert you want in the puller head.
Fitting the RCBS Bullet Puller Collet to Your Press
Setup is simple. The collet threads into the RCBS Standard Bullet Puller body, which uses the standard 7/8-14 die thread found on nearly every single-stage press. Run the ram up, snug the collet down on the bullet, then lower the ram to draw the case off the bullet. One note worth repeating: these collets are built for the standard RCBS collet-style puller and the puller body itself is sold separately, so grab the matching puller if you don't already have one on the bench.
Key Specifications
- Manufacturer: RCBS
- Manufacturer Part Number: 9435
- UPC: 076683094353
- Caliber: .44 Caliber / 11mm (.430 diameter)
- Type: Bullet Puller Collet
- Compatibility: RCBS Standard Bullet Puller (7/8-14 thread)
- Material: Steel
- Color: Silver
- Length: 2.55 in
- Quantity: 1
- Country of Origin: USA
What’s Included
- (1) RCBS Bullet Puller Collet, .44 Cal / 11mm (9435)
Frequently Asked Questions
Does the RCBS Bullet Puller Collet come with the puller body?
No, this is the collet only. It's an insert that threads into the RCBS Standard Bullet Puller, which is sold separately. If you don't already have the puller on your bench, you'll want to pick one up so you can use this collet.
What calibers does the .44 / 11mm collet work with?
It's sized for .430 diameter bullets, which covers the common .44-class cartridges. That includes .44 Remington Magnum, .44 Special, and .444 Marlin. If you load those rounds, this is the correct collet for pulling bullets.
Will pulling a bullet with this collet damage it?
The collet grips the bullet the way a lathe collet grips stock, locking down as the case is drawn away. This lets jacketed bullets come out without scoring the jacket or marring the tip, so you can reseat and reuse them. Reloaders note it pulls bullets clean with very little effort.
Does this collet fit any reloading press?
The RCBS Standard Bullet Puller it installs in uses the standard 7/8-14 die thread, which fits nearly every single-stage press. Just note it's made for the standard RCBS collet puller and will not work with the larger 1-14 thread puller.




Reviews
There are no reviews yet.