Description
There is a reason this muzzle device shows up on so many 14.5 inch barrel builds. At 2.25 inches long, the Daniel Defense Extended Flash Suppressor adds just enough length to bring a 14.5 inch barrel out to 16 inches when permanently attached, which is exactly why builders reach for it when they want a shorter, handier rifle without a stamp. Even if you are not doing a pin and weld, the extra length gives your barrel a clean, purposeful profile that looks right at home on a duty-style carbine.
Built Like Everything Else Daniel Defense Makes
This is an A2-style design with elongated vents cut around the body and a closed bottom port. That closed bottom matters more than people give it credit for. Shoot from prone on a dry range and an open-bottom device will kick up a dust cloud with every shot. This one keeps the ground where it belongs. The vents do a fine job of killing visible flash, which pays off in low light and keeps your night vision intact if you run it after dark. Daniel Defense machines it from aerospace-grade 17-4 stainless steel and treats it with a salt bath nitride finish, so corrosion resistance is baked in and upkeep stays minimal. It is made in the USA and backed by the company's 100 percent satisfaction guarantee against defects in materials and workmanship.
Fitment for the DD Extended Flash Suppressor
Threading is the standard 1/2-28 pattern, so it spins onto most .223 and 5.56 AR-15 barrels along with .22 caliber rimfire hosts sharing that thread pitch. Installation is straightforward: index it with a crush washer so the closed port sits at six o'clock, torque it down, and go shoot. If you are planning a permanent install on a 14.5 inch barrel, any competent gunsmith can handle the pin and weld in short order. Simple, durable, and effective, this is the kind of part you install once and never think about again.
Key Specifications
- Manufacturer: Daniel Defense
- Manufacturer Part Number: 06-048-08123
- UPC: 815604013949
- Thread Pitch: 1/2-28 TPI
- Overall Length: 2.25" (Extended)
- Caliber: .22 Caliber (.223/5.56)
- Material: Aerospace-Grade 17-4 Stainless Steel
- Finish: Salt Bath Nitride, Black
- Style: A2-Type Extended, Closed Bottom
- Platform: AR-15
- Shipping Weight: 0.215 lb
- Country of Origin: Made in USA
What’s Included
- Daniel Defense Extended Flash Suppressor, 1/2-28, 2.25"
Frequently Asked Questions
Will the Daniel Defense Extended Flash Suppressor work for a pin and weld on a 14.5 inch barrel?
Yes, and that is one of the most common reasons people buy it. The 2.25 inch extended length brings a 14.5 inch barrel to a 16 inch overall barrel length when permanently attached. Any experienced gunsmith can handle the pin and weld quickly.
What barrels does the 1/2-28 thread fit?
The 1/2-28 thread pitch is the standard pattern on nearly all .223 and 5.56 AR-15 barrels, so it fits the vast majority of AR builds out there. It also works on .22 caliber rimfire barrels that share the same threading. Just confirm your barrel is threaded 1/2-28 before ordering.
Why does the flash suppressor have a closed bottom?
The closed bottom port keeps muzzle blast from kicking up dust and debris when you shoot from prone or over any loose surface. The elongated vents around the rest of the body handle the flash reduction. It is a small design detail that makes a real difference on dusty ranges and in field conditions.
How do I install the Daniel Defense Flash Suppressor?
Installation is the same as any A2-style muzzle device. Use a crush washer to properly time the closed port to the six o'clock position, then torque it to spec with the correct wrench. If you are doing a permanent attachment for a shorter barrel, have a gunsmith pin and weld it in place.




Reviews
There are no reviews yet.