$19.99
39 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Getting your eye lined up behind a scope or sights shouldn't take a bunch of head wiggling and neck craning. The SME Stock Riser with Shell Loop solves that by adding height to your comb, giving you a repeatable cheek weld that puts your eye right where the optic wants it. Slip it over the buttstock, dial in the fit, and you're greeted with a full, clear sight picture instead of a black ring of shadow every time you mount up.
The riser ships with five foam inserts in graduated thicknesses of 1/8, 1/4, 3/8, 1/2, and 5/8 inch. You add or pull inserts to stack the comb height to match your scope's mounting height and your own build, no tools required. That kind of adjustability matters more than folks realize, since even a slightly off cheek weld shifts your eye position and opens the door to inconsistent shots. Higher-mounted optics, red dots on risers, and big-objective scopes all tend to sit above where a factory comb puts your face, and this closes that gap.
The body is made from 100 percent neoprene with a rubber-backed finish, so it grips the stock and stays put through recoil instead of creeping around. The neoprene also soaks up some of the felt recoil, which your cheekbone will thank you for after a long range session or a day chasing birds. It fits a wide range of rifle and shotgun stocks and stows away easy when you're done.
Along the side you get an elastic shell loop for keeping a handful of spare rounds right at the ready, handy for hunters who want fast access without digging through a pack. SME also built in swivel stud access so your existing sling attachment stays usable with the riser installed. It's a simple, affordable upgrade that makes an older or ill-fitting stock feel a whole lot more like it was built for you.
The riser is designed to slip over most standard rifle and shotgun buttstocks and hold in place with its rubber-backed neoprene. Because neoprene has some give, it stretches to fit a wide range of stock shapes and sizes. Measure the widest part of your comb if you want to be sure before ordering.
It comes with five foam inserts in thicknesses of 1/8, 1/4, 3/8, 1/2, and 5/8 inch. You add or remove inserts to raise or lower the comb height until your eye lines up naturally with your optic. No tools are needed, so you can fine-tune it right at the bench or in the field.
If you find yourself lifting your head, straining your neck, or hunting for the sight picture after mounting a scope, a riser usually fixes it. Taller-mounted optics and large objective scopes often sit above where a factory comb places your face, and a riser closes that gap. The payoff is a consistent cheek weld, which translates to more repeatable, accurate shots.
The elastic shell loop on the side holds a few spare rounds right on the stock for quick access. It's a nice touch for hunters who want ammo at the ready without reaching into a pack or pocket. The riser also keeps your swivel stud accessible so your sling still attaches normally.
| UPC | 888151021620 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | SMERSRSL |
| Product Type | Riser |
| Shipping Weight | 0.175 |
You must be logged in to post a review.
Reviews
There are no reviews yet.