$11.99
62 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
A smooth frontstrap is one of the most common complaints shooters have about factory 1911s. Once your hands get sweaty at the range or slick from rain, that bare metal gives your fingers nothing to bite into, and your grip starts shifting between shots. Hand checkering fixes that, but it is expensive, permanent, and means your pistol sits at a gunsmith's bench for weeks. The Wilson Combat 100B solves the same problem in about five minutes at your kitchen table.
This is a wraparound checkered frontstrap made from blued steel, designed to fit Government and Commander size 1911 frames. The wings of the sleeve tuck underneath your grip panels, so when you snug the grip screws back down, the panels clamp the frontstrap firmly against the frame. No drilling, no epoxy required, no permanent changes to your pistol. If you ever want to go back to a slick frontstrap or move the part to another gun, just pull the grips and lift it off. The only tool you need is the screwdriver you already use for your grip screws.
In use, the checkered texture gives your support fingers a positive, slip-resistant surface that keeps the gun planted through recoil and speeds up follow-up shots. Shooters who run it report a noticeably more consistent hold, especially on lightweight alloy frame carry guns where checkering the frame itself is not practical. It also pairs nicely with a checkered mainspring housing for grip texture all the way around, and it lets you run smooth or fancy grip panels without giving up control.
Wilson Combat has been building custom 1911s and parts since 1977, and this little upgrade reflects that same practical, shooter-first thinking. If your Government or Commander model came with a smooth frontstrap and you want more traction without the cost or commitment of hand checkering, the 100B is one of the easiest improvements you can make.
The sleeve wraps around the front of the grip frame, and its edges slide underneath your grip panels. When you reinstall the grips and tighten the screws, the panels clamp the frontstrap in place. No adhesive, drilling, or gunsmithing is required, though some shooters add a thin layer of adhesive for extra insurance on hard-use guns.
The 100B is made for Government and Commander size frames, which covers most full-size and mid-size 1911s from Colt, Springfield Armory, Auto-Ordnance, Norinco, Caspian, and similar makers. It is not intended for Officer or other compact frames out of the box, though some handy owners have trimmed it to fit smaller guns.
It gets surprisingly close. The checkered pattern gives your fingers a positive, slip-resistant surface that performs much like cut checkering, and when installed cleanly it can be tough to tell apart at a glance. Purists may still prefer checkering machined into the frame, but for a fraction of the cost and zero permanent modification, this is a very practical alternative.
It is a thin stamped steel sleeve, which is exactly why it can tuck under your grip panels and install without any frame modification. Despite the light construction, it holds up well in regular range use once it is clamped down properly by the grips. The thin profile also means it barely changes the feel of your grip circumference.
Yes, standard grip panels work fine since the sleeve is thin and sits flush against the frame. In fact, many shooters pair it with smooth or decorative grips because the frontstrap supplies the traction the panels lack. Just make sure your grip screws are snug so the panels keep constant clamping pressure on the part.
| UPC | 874218000028 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 100B |
| Product Type | Frontstrap |
You must be logged in to post a review.
Reviews
There are no reviews yet.