Description
The Glock 42 is a great little single-stack .380, but that short grip and slick factory frame can leave you wishing for a little more to hold onto. The Talon Grips 108R fixes that in a few minutes without permanently changing a thing. This is a pre-cut adhesive wrap made specifically for the G42, so it follows every contour of the frame and sits flush instead of looking like a bolt-on afterthought. At less than half a millimeter thick, it adds grip texture without adding diameter, which matters a lot on a pistol you're carrying tight against your body.
What the Talon 108R Rubber Texture Feels Like
The rubber texture is Talon's most popular and most versatile option, and it's the one to reach for if you carry. It's aggressive enough to keep your hand planted through recoil, but it won't shred your shirts or irritate bare skin the way the granulate (sandpaper-style) version can. Folks with softer hands tend to appreciate this texture too. If you bounce between an IWB holster and open carry, or you just want more control without the bite, the rubber is the sweet spot.
Coverage and Fit on Your Glock 42
This is a rear-wrap grip with full coverage on the side panels including above the thumb rest, high coverage on the backstrap, and full coverage under the trigger guard. It comes cut with reliefs for the thumb rests on each side and cutouts for the GLOCK logo on the left and Talon's T on the right, so the branding still shows through clean. Made in the USA.
Installing the Talon 108R
Installation is genuinely simple. Wipe the frame down with rubbing alcohol so it's clean and dry, peel the backing, line the panels up, then press them into place and hit them with a hair dryer or heat gun to activate the adhesive. Give it around 24 hours to fully cure before you run it hard. Once it's set, it stays put through sweat, heat, and holster wear, and if you ever want it off it peels away cleanly with little to no residue.
Key Specifications
- Manufacturer: Talon Armament
- Manufacturer Part Number: 108R
- UPC: 812308020440
- Product Type: Adhesive Grip
- Fits: Glock 42
- Texture: Rubber
- Color: Black
- Material: Textured Rubber
- Style: Rear Wrap
- Thickness: Less than 0.5mm
- Country of Origin: Made in USA
What’s Included
- Talon Grips 108R pre-cut adhesive grip panels for Glock 42
- Installation instructions
Frequently Asked Questions
How is the rubber texture different from the granulate version?
The rubber texture is the more comfortable, carry-friendly choice. It gives you a secure, tacky hold without feeling abrasive against skin or snagging on clothing. The granulate version is more like sandpaper and is better suited to open carry or range use where you want maximum bite.
How do I install the Talon 108R on my Glock 42?
Clean the frame with rubbing alcohol and let it dry completely, then peel the backing, align the pre-cut panels, and press them onto the frame. Warm the grip with a hair dryer or heat gun to activate the adhesive and press firmly as it cools. Let it cure for about 24 hours before heavy use.
Does the grip come off cleanly if I want to remove it?
Yes. Once properly installed the Talon grip stays put through sweat and holster wear, but when you want it gone it peels off with little to no residue. Any leftover adhesive cleans up easily with isopropyl alcohol, and there's no permanent modification to your Glock 42 frame.
Will the 108R add bulk to my Glock 42 grip?
No. At less than half a millimeter thick, it adds texture and control without changing the diameter of the grip. That low profile is a big reason it's a favorite for concealed carry, since it keeps the G42 slim and snag-free.



Reviews
There are no reviews yet.