Description
The ProMag PM201 tackles one of the oldest quirks of the Ruger 10/22: the steel bolt slamming into the steel bolt stop pin every single time you pull the trigger. That constant metal-to-metal impact is what causes the familiar clack you hear when the action cycles, and over thousands of rounds it can start to peen out the pin holes in the aluminum receiver. This buffer replaces that plain steel pin with high-density polyurethane, giving the bolt something softer to bottom out against.
What the PM201 Buffer Does on the Range
Most folks notice the gun runs a little smoother and quieter right away, and if you're shooting suppressed the difference is even more obvious since you're cutting out that steel-on-steel slap that a can can't do anything about. It won't turn a 10/22 into a target rifle by itself, but as a cheap, easy tweak it earns its keep. The buffer is lightweight, holds up well to regular shooting, and shrugs off oils and solvents, so a good bore cleaner won't degrade it.
Installing the ProMag Recoil Buffer
This is about as simple as gun work gets. It's a true drop-in part with no fitting or modifications needed. You punch out the factory steel bolt stop pin at the rear of the receiver, drop the orange buffer in its place, and you're done. A punch and a couple of minutes is all it takes, which makes this a great first upgrade for anyone new to tinkering with their rimfire.
It fits the Ruger 10/22, the 10/22 Charger, and the 10/22 Magnum across rifle and carbine variants. Since these are a wear item that can eventually deform with heavy use, getting three in a pack is handy. Keep one in the gun, toss a spare in your range bag, and hang onto the third for down the road. Made in the USA.
Key Specifications
- Manufacturer: ProMag
- Manufacturer Part Number: PM201
- UPC: 708279009488
- Product Type: Recoil Buffer
- Material: High-density polyurethane
- Color: Orange
- Fits: Ruger 10/22, 10/22 Charger, 10/22 Magnum
- Function: Replaces the bolt stop pin
- Installation: Drop-in, no modifications required
- Quantity: 3 buffers per pack
- Country of Origin: Made in USA
What’s Included
- 3 ProMag PM201 polyurethane recoil buffers
Frequently Asked Questions
What does the ProMag PM201 recoil buffer actually do?
It replaces the steel bolt stop pin at the rear of your 10/22 receiver with a polyurethane one. This gives the bolt a softer surface to bottom out against, which cuts down the metal-to-metal clack and helps protect the pin holes in the aluminum receiver from getting battered over time. Most shooters also notice the action feels a bit smoother.
Is the PM201 buffer hard to install on a Ruger 10/22?
Not at all. It's a true drop-in part with no fitting or gunsmithing needed. You just punch out the factory steel pin at the back of the receiver, set the orange buffer in its place, and you're back in business in a couple of minutes with nothing more than a punch.
Will this recoil buffer help with a suppressed 10/22?
Yes, this is one of the more popular reasons people run one. On a suppressed setup the loudest thing left is often the bolt slapping the steel pin, and swapping in a polyurethane buffer removes that steel-on-steel noise for noticeably quieter cycling.
Why does the ProMag buffer come in a 3-pack?
Recoil buffers are a wear item, so over a lot of rounds the polyurethane can eventually deform and need replacing. Getting three means you can run one now and keep a couple of spares in your range bag or on the shelf so you're never caught without one.



Reviews
There are no reviews yet.