$17.99
Out of stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The Cross Armory CRGPSSV replaces the three factory frame pins on your Glock Gen 1-3 with a matched set that's machined to hold up and dressed in a clean silver finish. You get all three pins in one package: the locking block pin, the grooved trigger pin, and the trigger housing pin. It's a small change that makes a real difference when you're building out a custom frame and want the details to match instead of that stock black.
These aren't cast pins. Cross Armory precision machines them from steel, then surface treats them for a better finish and corrosion resistance, so they stand up to range time and cleaning cycles without looking beat up. The dimpled design keeps everything seated the way it should, and the enhanced geometry is built to shave a little frustration off install time. If you've ever fought a stubborn pin during a trigger job, you'll appreciate the effort.
This set covers a wide swath of the Gen 1-3 lineup, including the 17, 19, 20, 21, 22, 23, 24, 26, 27, 29, 30, 31, 32, 33, 34, 35, 38, and 39. It also plays nicely with plenty of Gen 3-compatible frames like Polymer80 builds, the PSA Dagger, Lone Wolf Timberwolf, and Shadow Systems, so it's a solid pick whether you're working on a factory pistol or an 80 percent project. It does not fit the 42, 43, or 43x.
Since you're already pushing these pins out anytime you install a new trigger connector or service the frame, this set is an easy add to that same wrench-turning session. The pins drive out left to right in order, and dropping in a fresh matched set means no worrying about a scratched-up factory pin ruining the look of an otherwise clean build. Cross Armory backs the set with a satisfaction guarantee, which is a nice bit of peace of mind for a part this fundamental.
You get the three frame pins found on a Gen 1-3 Glock: the locking block pin above the trigger, the grooved trigger pin, and the trigger housing pin at the rear of the grip. All three arrive in one package with a matching silver finish. That covers every frame pin you'd remove during a trigger group service.
It fits a wide range of Gen 1-3 models including the 17, 19, 20, 21, 22, 23, 24, 26, 27, 29, 30, 31, 32, 33, 34, 35, 38, and 39. It also works with many Gen 3-compatible frames like Polymer80, the PSA Dagger, Lone Wolf, and Shadow Systems. It does not fit the 42, 43, or 43x.
Not at all if you've done any frame work before. The pins drive out and back in left to right using a punch, with the trigger pin being the one you want to keep track of direction on since it has grooves that seat into the slide stop. Since you're already pulling these pins during a trigger connector swap, it's an easy add to that same job.
They're precision machined from steel rather than cast, then surface treated for a cleaner finish and corrosion resistance. The dimpled design helps keep them seated so they don't walk during use. Cross Armory also backs the set with a satisfaction guarantee.
| UPC | 617566987005 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | CRGPSSV |
| Model |
You must be logged in to post a review.
Reviews
There are no reviews yet.