Description
Intermediate gas systems sit right between mid-length and rifle-length, and they show up on 18 to 20 inch builds like SPRs and 6.5 Grendel setups where you want smoother cycling and a little extra dwell time. The Lantac M-Spec Intermediate Gas Tube is the part that carries hot gas from the block back to the bolt carrier group, and Lantac builds it from 306 stainless steel extruded tube for corrosion resistance and long service life. If your barrel is drilled for an intermediate port, this is the tube you need to make it run.
What Sets the Lantac M-Spec Gas Tube Apart
Lantac holds tight tolerances on these, so you get consistent dimensions and proper alignment when it drops into your gas block. The stainless finish keeps things bright and resists rust without any coating to wear off over time. Each tube is laser engraved and manufactured in the USA, which is a nice touch on a part most people never see once the handguard goes back on.
Fitment Notes Before You Order Your Intermediate Gas Tube
Here's the thing worth double-checking: not all intermediate systems are cut the same. Lantac's intermediate tube measures out to fit standard intermediate ports, but it will not fit the Wilson Combat intermediate system that calls for a shorter tube. Confirm your barrel's gas port location and required tube length before you buy, since an intermediate tube is not interchangeable with a mid-length or rifle-length part. Getting the right length is what keeps your rifle cycling reliably instead of short-stroking or beating up the upper.
Installing the M-Spec Intermediate Gas Tube
The tube ships with its gas tube roll pin, so you have what you need to pin it into the gas block. It's a straightforward job with a bench block and the right punch, and once it's seated and the roll pin is set, you're ready to reassemble. Whether you're building fresh or replacing a worn tube, this is a solid, no-drama choice for an intermediate AR build.
Key Specifications
- Manufacturer: Lantac USA
- Model: M-Spec Gas Tube
- Manufacturer Part Number: 01-MSPEC-GT-INT
- UPC: 640117876305
- Gas System Length: Intermediate
- Material: 306 Stainless Steel Extruded Tube
- Finish: Stainless Steel
- Color: Silver
- Overall Length: 15.85 in
- Product Type: Gas Tube
- Fitment: AR-15 Intermediate-Length Gas System
- Marking: Laser Engraved
- Country of Origin: Made in the USA
What’s Included
- Lantac M-Spec Intermediate Length Gas Tube
- Gas Tube Roll Pin
Frequently Asked Questions
What barrels does the Lantac M-Spec Intermediate Gas Tube work with?
It's made for AR-15 barrels drilled for an intermediate-length gas port, which you'll typically see on 18 to 20 inch builds like SPRs and 6.5 Grendel rifles. Intermediate sits between mid-length and rifle-length, so it is not interchangeable with either. Always confirm your barrel's gas system length before ordering.
Does this intermediate gas tube fit a Wilson Combat intermediate system?
No. Lantac's intermediate tube is longer than what the Wilson Combat intermediate system requires, so it will not fit that setup. Wilson's intermediate uses a shorter tube, so check your specific barrel spec first.
Does the M-Spec gas tube come with a roll pin?
Yes, it ships complete with the gas tube roll pin, so you have what you need to pin it into the gas block. You'll want a bench block and the correct roll pin punch to seat it cleanly during install.
Why choose a stainless steel gas tube over a nitrided one?
Stainless gives you natural corrosion resistance and a bright silver finish without a coating that can wear over time. Lantac's 306 stainless tube is precision made to mil-spec dimensions for reliable fitment. If you prefer a blackened, low-glare look, Lantac also offers nitrided versions in other lengths.





Reviews
There are no reviews yet.