Description
The Streamlight TLR-6 solves a problem most subcompact carriers run into: there's just no rail to hang a light on. This model is cut specifically to clamp onto the trigger guard of the Smith & Wesson M&P Shield 9 and M&P Shield 40, so it hugs the frame and keeps the gun's slim profile intact. You get a C4 white LED throwing 100 lumens and 2,000 candela out to 89 meters, paired with a 640 to 660nm red aiming laser sitting just below the light. For a unit this tiny, that's a genuinely useful amount of output for identifying what's in front of you before you ever make a decision.
Running the TLR-6 on Your Shield
Control is dead simple. Ambidextrous push-button switches on both sides cycle three modes: laser only, laser and LED combo, or LED only. Whether you're right or left handed, it works the same. All modes have a built-in 10-minute auto shutoff, which is a small mercy if you ever bump it on inside a bag or holster and forget about it. Runtime lands at about one hour in LED or combo mode and up to 11 hours running the laser alone.
Zero That Holds and Batteries You Can Swap Fast
The red laser adjusts for windage and elevation through screws mounted in brass bushings, which is a big deal for a light in this price range. That brass helps the laser hold its zero over time instead of drifting after a few range sessions. Even better, when it's time to change batteries you don't pull the whole unit off the gun. Swap the two CR 1/3N lithium cells with the light still mounted and your laser stays sighted in, no re-zero needed.
Built to Take a Beating
The housing is impact-resistant polymer rated to survive a one-meter drop, and it carries an IPX4 water-resistant rating for rain and splashes. The whole thing is serialized for identification and assembled in the USA. If you carry an M&P Shield for everyday defense and want light and a laser without turning your pocket pistol into a brick, this is one of the cleanest ways to do it.
Key Specifications
- Model: TLR-6
- Manufacturer Part Number: 69273
- UPC: 080926692732
- Fits: S&W M&P Shield 9 and M&P Shield 40
- Light Output: 100 lumens
- Peak Beam Intensity: 2,000 candela
- Beam Distance: 89 meters
- Light Source: C4 White LED
- Laser: 640-660nm Red Aiming Laser
- Modes: Laser only, LED/Laser combo, LED only
- Runtime: 1 hour (LED or combo), up to 11 hours (laser only)
- Battery: (2) CR 1/3N Lithium (included)
- Water Resistance: IPX4
- Impact Resistance: 1 meter tested
- Color: Black
- Weight: 1.27 oz
What’s Included
- Streamlight TLR-6 white LED / red laser unit
- (2) CR 1/3N lithium batteries
- Instructions/manual
Frequently Asked Questions
Will the TLR-6 fit any M&P Shield?
This model is cut specifically for the Smith & Wesson M&P Shield 9 and M&P Shield 40. It mounts to the trigger guard rather than a rail, so it also works on the Shield Plus variants in those calibers. It's worth confirming your exact model against Streamlight's fit guide before ordering, since the TLR-6 comes in gun-specific versions.
Do I have to remove the light to change the batteries?
No, and that's one of the nicer touches on this unit. You can swap the two CR 1/3N lithium batteries while the TLR-6 stays mounted on your Shield. Because you're not pulling the housing off, the laser holds its zero and there's no need to re-sight after a battery change.
How bright is 100 lumens for a carry gun?
For a light this compact, 100 lumens is plenty to identify a target in low light at typical defensive distances. It won't out-throw a full-size duty light, but it isn't trying to. On a subcompact like the Shield, the tradeoff of small size for reasonable output is exactly the point, and most users find the beam more than enough for the job.
Does the red laser hold its zero over time?
It's designed to. The windage and elevation adjustment screws are mounted in brass bushings, which helps the laser stay put through recoil and repeated range trips instead of drifting. Once you sight it in, it should stay dependable session after session.







Reviews
There are no reviews yet.