Description
Cleaning a barrel used to mean a rod, a stack of patches, and a lot of elbow grease. The Otis Foaming Bore Cleaner takes a smarter route. You spray it into the breech end, and the foam expands to fill the entire bore so it makes contact with every bit of rifling, including the top surfaces where liquid solvents tend to run off and pool at the bottom. Give it time to work on the fouling, and most of the mess wipes right out on a dry patch. It comes in a compact 3 oz can that's easy to toss in a range bag or keep on the bench.
How the Otis Foaming Bore Cleaner Works
The idea is simple: let the chemistry and a little patience do the job instead of your arm. Lay the firearm horizontally with the breech slightly higher than the muzzle, spray the foam in until the bore is full, and let it sit until it breaks down. As it does its thing, it lifts carbon and metal fouling off the barrel walls. Folks who use foam cleaners usually give it somewhere in the 10 to 20 minute range for routine cleaning, and heavier fouling can sit longer. When the dwell time's up, run the fouling out with an Otis Breech-to-Muzzle cleaning kit or a Ripcord and finish with a light coat of lube and protectant.
Where the Otis Foam Earns Its Keep
This is a great fit for regular maintenance after a range session, and it shines on handguns and rifles alike where getting a rod down the barrel is a pain. The full-bore foam coverage means you're not chasing dry spots the way you do with a straight liquid solvent. It pairs naturally with the rest of the Otis cleaning lineup, so if you already run their pull-through gear, this drops right into your routine. For a barrel that's been neglected or shot hard, a second application and a longer soak will pull out more of what's hiding in the grooves.
Key Specifications
- Manufacturer: Otis Technology
- Model: Foaming Bore Cleaner
- Manufacturer Part Number: RW-903-A-FC
- UPC: 014895004203
- Product Type: Bore Cleaner
- Size: 3 oz
- Form: Expanding foam spray
- Application: Spray into breech end
- Quantity: 1 can
What’s Included
- One 3 oz can of Otis Foaming Bore Cleaner
Frequently Asked Questions
How long should I let the Otis Foaming Bore Cleaner sit in the bore?
For routine cleaning, letting the foam dwell for roughly 10 to 20 minutes is a solid starting point. Let it work until it breaks down, then patch it out. If your barrel is heavily fouled, a second application and a longer soak will pull out more carbon and copper.
How do I get the foam out of the barrel?
Once the foam has broken down, run the fouling out using an Otis Breech-to-Muzzle cleaning kit or a Ripcord pull-through. Push patches through until they come out clean and dry. Finish with a light pass of lubricant and protectant to guard the bore.
What's the right way to position the firearm when applying it?
Make sure the firearm is unloaded first. Place it in a gun vise or lay it horizontally with the breech slightly higher than the muzzle, then spray the foam into the breech end until the bore is full. Keeping it positioned this way helps cut down on fouling seeping into the action as the foam goes to work.
Does the Otis Foaming Bore Cleaner remove carbon and copper?
Yes, it's designed to break down carbon build-up and lift fouling from the bore. Foam cleaners like this fill the full circumference of the barrel so the chemistry stays in contact with the rifling and grooves. For stubborn copper, a longer dwell time or a repeat application usually does the trick.




Reviews
There are no reviews yet.