0
0

KynSHOT PB6004 Hydraulic Guide Rod for Glock 17 Gen 5

UPC: 854476005423

$129.99

16 in stock

Online inventory may differ from in-store availability. 

Fast Shipping

Quick turnaround so you get your gear sooner.

Secure FFL-Friendly Checkout

Trusted checkout with industry-standard protection.

Family-Owned Business

Keeping Traditions Alive Since 1953

Secure Transactions provided with

Description

Glock 17s are workhorses, but the stock recoil spring assembly leaves plenty of performance on the table. The KynSHOT PB6004 swaps in where your factory guide rod lives and uses a sealed hydraulic damper to control how hard and how fast the slide moves. Instead of relying on spring tension alone, it absorbs and meters the energy of the cycle, which means less snap in the hand and a flatter-shooting gun that settles back on target quicker.

What the PB6004 Does for Your Glock 17

The short version is that it slows the slide down in a controlled way. KynSHOT's testing shows roughly a 70 percent reduction in total recoil motion, with shot recovery time coming in under half a second. That translates to less muzzle rise, steadier sights between shots, and noticeably less fatigue during long range sessions. If you run a red dot, the calmer slide movement helps keep the dot settled in the window so you're not hunting for it after every shot.

Built to Take a Beating

The PB6004 is machined from high-strength 17-4 stainless steel throughout and sealed with mil-spec hydraulic fluid and seals. It's corrosion resistant and rated for ambient temps from -30F up to 150F, so it holds up whether you're shooting in summer heat or winter cold. Overall length runs 2.96 inches, 2.88 inches once installed in the slide, and the whole unit weighs in at a hair over half an ounce.

Fitment and Setup

This particular model, the PB6004, is designed for the Glock 17 Gen 5 slide and similar platforms. Installation is the same as swapping any factory guide rod: lock the slide back, pull it off the frame, drop the stock assembly out, and set the KynSHOT in its place. There's nothing to tune or adjust. The self-compensating damping profile is built to run across a wide range of ammo, from light practice loads to hotter defensive rounds, with no fiddling on your end.

Key Specifications

  • Manufacturer: KynSHOT
  • Manufacturer Part Number: PB6004
  • Model: PB6004
  • UPC: 854476005423
  • Fitment: Glock 17 Gen 5 slide and similar platforms
  • Type: Hydraulic recoil-reducing guide rod
  • Material: 17-4 Stainless Steel
  • Color/Finish: Silver, corrosion resistant
  • Recoil Reduction: Up to 70% of total recoil motion
  • Shot Recovery Time: Under 0.5 seconds
  • Overall Length: 2.96 in
  • Installed Length: 2.88 in
  • Weight: 0.61 oz
  • Operating Temp Range: -30F to 150F
  • Fluid/Seals: Mil-spec hydraulic fluid and seals

What’s Included

  • 1x KynSHOT PB6004 Hydraulic Guide Rod

Frequently Asked Questions

Will the KynSHOT PB6004 fit my Glock 17?

The PB6004 is designed as a direct drop-in replacement for the Glock 17 Gen 5 slide and similar platforms. It replaces your factory guide rod assembly with no modifications to the firearm. If you're running a different generation or model, check the KynSHOT lineup for the version matched to your slide.

Do I need a gunsmith or any special tools to install it?

No. Installation is the same as a standard guide rod swap: field strip the pistol, pull out the factory assembly, and drop the KynSHOT in its place. There's nothing to tune, adjust, or trim, and you can have it done in a couple of minutes at the bench.

Does it work with different types of ammo?

Yes. The self-compensating damping profile is built to handle a wide range of loads without adjustment, from lighter practice ammo to hotter defensive rounds. You don't have to match a specific spring weight to your ammo like you would with some aftermarket setups.

How much does it really reduce recoil?

KynSHOT's test data shows roughly a 70 percent reduction in total recoil motion with shot recovery times under half a second. In practice that means a flatter-shooting gun with less muzzle rise, which helps your sights or red dot settle faster between shots and cuts down on fatigue over a long range day.

Additional information

UPC

854476005423

Manufacturer

Manufacturer Part Number

PB6004

Color

Silver

Model

Reviews

There are no reviews yet.

Be the first to review “KynSHOT PB6004 Hydraulic Guide Rod for Glock 17 Gen 5”