$87.99
9 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Suppressors are great until your gas gun starts spitting carbon back through the charging handle. Fletcher Rifle Works built the Texas Flood with a solution baked right into the design, and this vented .308 end cap is the key that unlocks it. Swap it on in place of the solid cap and the outer annulus of the can opens up, giving combustion gases a faster exit path instead of forcing everything back toward the action. The result is noticeably lower back pressure, a cleaner running rifle, and a host that is much easier to dial in with an adjustable gas block.
There is a trade involved, and it is worth understanding before you buy. Venting the can does bump the sound signature up a bit compared to running the solid cap. That makes this cap the right call for high round count range sessions, gassy or stubborn hosts that fight you on tuning, and anyone who values comfort behind the gun over squeezing out the last decibel. Since the Texas Flood ships with solid caps, you are not locked into one setup. Run the vented cap for hard use days and thread the solid one back on when you want maximum quiet.
The cap wears a black Cerakote finish that matches the rest of the Texas Flood lineup, and it fits the shared front thread pattern used across the Texas Flood and OCL Infinity suppressors. The .308 bore keeps you covered from 5.56 wildcats up through the .30 caliber cartridges the can is rated for on the right host. If your suppressed gas gun has been running dirty or fighting your tuning efforts, this little cap fixes more problems than its size suggests.
The vented cap opens up the outer annulus of the Texas Flood, giving propellant gas a quicker path out the front of the can. That drops back pressure significantly, which means less gas and carbon blowing back through the action and into your face. It also makes gas guns with adjustable blocks much easier to tune and keeps the whole system running cleaner.
Yes, a little. Venting gas out the front trades some sound suppression for reduced back pressure, so the can will have a slightly higher sound signature than it does with the solid cap installed. Most people running high round counts or gassy hosts consider it a worthwhile trade, and you can always swap the solid cap back on for hunts or situations where maximum quiet matters most.
Fletcher Rifle Works uses the same front cap interface on the Texas Flood and the OCL Infinity, so this vented cap works on both. It is not a universal part though, so do not expect it to thread onto cans from other manufacturers. If you run a different Fletcher suppressor, check the cap pattern before ordering.
You can. The .308 bore has plenty of clearance for smaller diameter projectiles, so it works fine on 5.56 hosts. You give up a touch of suppression compared to a caliber matched 5.56 cap, but for a lot of people the flexibility of one cap covering everything up to .30 caliber is worth it, especially on a multi-caliber can like the Texas Flood.
| UPC | 850044307784 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | TXF308VENT |
You must be logged in to post a review.
Reviews
There are no reviews yet.