Description
This is a single .348 diameter steel neck bushing made to drop into RCBS Gold Medal Match series sizing dies. It gives you control over one of the most important variables in precision handloading: how tightly the case neck grips the bullet. Instead of a fixed-diameter die that sizes every neck the same way, a bushing setup lets you pick the exact amount of tension your load and your brass call for.
The bushing self-centers on the case neck as the case enters the die, which helps keep everything concentric and cuts down on runout. Because it only sizes the neck to the diameter you choose, the brass isn't overworked on every pass. That means less work hardening, longer case life, and the kind of consistency that shows up on paper when you're chasing tight groups.
Where the .348 Steel Neck Bushing Fits In
This one measures .348 inches, so it lands in the range used by larger calibers and heavier neck-wall brass. RCBS suggests keeping a couple of bushings on hand one to two thousandths above and below your target size so you can fine-tune tension without guessing. To find your number, measure the outside neck diameter of a loaded round and subtract about .002 to .003 inch, which leaves roughly .001 inch of spring-back for proper grip.
Getting the Most From This Neck Bushing
The sizing surface is hand-polished hardened steel, running around Rc 60 to 62 for hardness, which keeps sizing effort down and holds its dimension over a long working life. These ship in bare steel, so run your usual case lube to keep things smooth. You'll get the best results pairing this bushing with quality brass that has consistent neck-wall thickness, since the bushing can only be as consistent as the brass you feed it. For benchrest and long-range loaders, it's a small part that makes a real difference in ammo quality.
Key Specifications
- Manufacturer: RCBS
- Bushing Diameter: .348 in
- Material: Hardened, hand-polished steel
- Surface Hardness: Rc 60-62
- Finish: In-the-white bare steel (case lube required)
- Design: Self-centering, interchangeable
- Compatibility: RCBS Gold Medal Match series bushing dies
- Manufacturer Part Number: 81663
- UPC: 076683816634
What’s Included
- One .348 RCBS steel neck sizing bushing
Frequently Asked Questions
What dies does the .348 steel neck die bushing work with?
It's designed for the RCBS Gold Medal Match series bushing-style sizing dies. Redding, Wilson, and Hornady neck bushings share the same standard, and RCBS bushings can generally be used in those systems as well. It is not made to fit standard Custom Grade or non-bushing dies.
How do I know if .348 is the right bushing size for my load?
Measure the outside neck diameter of a loaded cartridge and subtract about .002 to .003 inch. That leaves roughly .001 inch of spring-back so the neck holds the bullet with the right tension. Another way is to double your neck-wall thickness, add the bullet diameter, and subtract .001 inch.
Do I need to lubricate this neck bushing?
Yes. These ship in bare steel, so traditional case lube on the necks keeps sizing smooth and protects the brass. The polished surface and Rc 60-62 hardness already reduce sizing effort, but lube still matters for clean, consistent results.
Why buy a bushing instead of a standard neck sizing die?
A bushing lets you set the exact neck tension for your brass rather than accepting a fixed factory diameter. It only sizes the neck as much as needed, which reduces work hardening and stretches case life. Many reloaders keep a few sizes on hand to tune tension for accuracy.




Reviews
There are no reviews yet.