Description
Most stabilizers bolt onto the front of your bow and stick out there doing their job from a distance. The Viper Dovetail Stabilizer takes a different route by sliding directly into the dovetail slot on Mathews Bridgelock risers, putting that stabilizing weight inside the bow's structure instead of way out front. The result is a tighter, cleaner setup that still gives you the balance and vibration control you're after, just without the extra length hanging off the riser.
Built To Tuck Into A Mathews Bridgelock Riser
Machined from 6061 aluminum, this 10-inch version comes finished in Slate Grey to match up nicely with darker riser colors. It carries a 4 oz. powder-coated steel weight on the end, and because the mounting stud is a standard 5/16-24 thread, you can extend it out and stack on additional weight if you want more front-end bias for your particular arrow and sight setup. A set screw knob locks everything in place once you've found the balance point you like, and loosening it back up lets you slide the whole unit forward or backward to fine-tune that balance without pulling it off the bow.
Vibration Control Without The Extra Bulk
A coil rubber dampener sits built into the design to pull hand shock and vibration out of the shot, which matters just as much on a stabilizer that lives inside the riser as it does on one out front. Because the weight stays close to the bow rather than extending several inches away, you end up with a setup that's noticeably easier to maneuver through brush, in a treestand, or squeezed into a ground blind, without giving up the dampening benefit stabilizers are built to provide.
This particular model is built specifically around the Bridgelock dovetail system, so fit is dependent on having that mounting slot on your riser. It's also available in 8-inch and 12-inch lengths and a few different finish options if Slate Grey isn't quite what your bow calls for.
Key Specifications
- Length: 10 inches
- Weight: 4 oz. powder-coated steel weight
- Material: 6061 aluminum
- Finish: Slate Grey
- Mounting System: Dovetail riser mount, fits Mathews Bridgelock
- Vibration Dampening: Coil rubber dampener
- Mounting Stud: 5/16-24 stainless, extendable for added weight
- Adjustment: Set screw knob for slide and lock positioning
- Manufacturer: Viper
- Manufacturer Part Number: DTS-10SG
- UPC: 813062019183
What’s Included
- Viper Dovetail Stabilizer, 10 in., Slate Grey
- 4 oz. powder-coated steel weight
- Coil rubber dampener
- 5/16-24 stainless mounting stud
- Set screw knob
Frequently Asked Questions
Will the Viper Dovetail Stabilizer fit any Mathews bow?
It's built for the Bridgelock dovetail riser system, so it fits Mathews models that have that mounting slot. If your riser doesn't have a Bridgelock dovetail, this particular stabilizer won't mount up correctly.
Can I add more weight than the included 4 oz.?
Yes, the mounting stud is a standard 5/16-24 thread that can be extended, so you can thread on additional weights if you want a heavier front bias. This gives you some room to tune balance beyond what comes stock on the stabilizer.
How do I adjust the balance position on this stabilizer?
Loosen the set screw knob, slide the stabilizer forward or backward within the dovetail slot to the position you want, then tighten the knob back down to lock it in. It's a quick adjustment you can make at the range as you dial in your hold.
Does the coil rubber dampener actually cut down on vibration?
It's designed to absorb hand shock and vibration right at the shot, which is the same job a rubber dampener does on a traditional front-mounted stabilizer. Since the weight sits inside the riser rather than hanging off the front, you get that dampening effect in a more compact package.




Reviews
There are no reviews yet.