Description
The .300 Win Mag has earned its place as one of the great all-around big game and long-range cartridges, and building your own loads for it starts with good brass. These Remington cases come new and unprimed, which means you get full control over primer selection, powder charge, and seating depth from the very first firing. For anyone chasing tight groups or squeezing the most out of a magnum rifle, starting with fresh, uniform brass is a big part of the equation.
What Sets This Remington .300 Win Mag Brass Apart
Remington runs its brass through a drawing process that helps keep wall thickness and dimensions consistent, which pays off in more even ignition and repeatable pressure. It's worth noting that Remington brass tends to run on the thicker, heavier side compared to some other brands, so internal case volume is a touch smaller. That's not a knock, it just means you should start low and work your load up rather than borrowing a max charge developed with a different headstamp.
Prepping Your Remington Unprimed Rifle Brass
Like most new brass, these cases benefit from a quick once-over before you load them. A lot of reloaders will run a light chamfer and deburr on the case mouths, uniform the primer pockets, and give the flash holes a look. The .300 Win Mag is a belted magnum that headspaces off the belt, so pay attention to your shoulder bump when you full-length size, since managing that shoulder is the key to long case life on this cartridge. It uses a large rifle magnum primer, so have those on hand.
Getting the Most Out of Your Brass
These cases hold up well through multiple reloading sessions when you don't push them to the ragged edge every time. If you plan on running near-max magnum loads, annealing the necks every few firings will add strength and stretch out how many cycles you get. Keep good notes, keep the brass sorted by how many times it's been fired, and this Remington brass will give you plenty of dependable loads to work with. Always check current load data in a trusted reloading manual before you get started.
Key Specifications
- Manufacturer: Remington
- Caliber: .300 Winchester Magnum
- Product Type: Unprimed Rifle Brass Cases
- Quantity: 50 Count
- Condition: New / Unprimed
- Case Type: Belted, Bottleneck Brass
- Primer Size: Large Rifle Magnum
- Bullet Diameter: .308 in
- Manufacturer Part Number: 22876
- UPC: 047700448305
- Shipping Weight: 1.85 lbs
What’s Included
- 50 Remington unprimed .300 Win Mag brass cases, factory bagged
Frequently Asked Questions
Do these Remington .300 Win Mag cases come primed or unprimed?
They come completely unprimed and new, bagged at the factory. This lets you choose your own large rifle magnum primer and build the load exactly how you want it. You'll need to supply your own primers, powder, and bullets.
Does this Remington unprimed brass need prep before reloading?
New brass is cleaner and more uniform than once-fired, but a light prep goes a long way. Most reloaders chamfer and deburr the case mouths, uniform the primer pockets, and check the flash holes before loading. Running the cases through a sizing die first is also a common step to true them up.
Can I use max load data from a manual with this Remington brass?
Be careful here. Remington brass tends to be a bit thicker with slightly less internal capacity than some other brands, which can raise pressures. Start below max and work your load up in your own rifle rather than jumping straight to a max charge developed with different brass.
How many times can I reload this .300 Win Mag brass?
That depends on how hot you run your loads and how well you manage case sizing. Kept to moderate pressures with proper shoulder bump, these cases will give you several reloading cycles. Annealing the necks every few firings will add strength and extend case life, especially with near-max magnum loads.




Reviews
There are no reviews yet.