$10.99
7 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The disconnector is one of those parts nobody thinks about until it starts causing problems. It's a small piece riding inside your trigger group, but it plays a big role in how clean your trigger reset feels and how reliably your rifle cycles from shot to shot. WMD Guns took a stock component and gave it their NiB-X nickel boron treatment, turning an easily overlooked part into a legitimate upgrade for anyone running a mil-spec small pin lower.
What makes this disconnector worth a second look is the coating itself. NiB-X is a nickel boron finish that's noticeably harder and slicker than the phosphate coating found on standard parts, so metal-on-metal contact stays smoother even after the coating has seen thousands of cycles. Carbon has a much harder time bonding to the surface too, which means less buildup fouling up your trigger mechanism between range trips. A lot of guys who run these report a cleaner, crisper break and less gritty feel once it's dropped in.
Beyond the coating, WMD machined this disconnector with a slightly larger contact surface and a subtle radius that helps reduce over-travel and drag if it happens to sit a little deep in the trigger group. That translates into better tactile feedback right at the wall, which trigger nerds will appreciate and casual shooters will notice even if they can't quite explain why the trigger feels better.
This part is built as a straightforward swap for the disconnector already in your mil-spec small pin lower. Most builders can get it installed in a few minutes with basic punches, though rifles running unusually stiff buffer springs are better handled by someone who works on triggers regularly, just to keep from bending anything during install. Once it's seated, there's no additional fitting or adjustment needed.
If your current disconnector has some miles on it, or you're just building a lower parts kit and want components that'll outlast the mil-spec norm, this is a cheap way to upgrade a part that genuinely affects how your rifle runs day to day.
This disconnector is built for mil-spec small pin lowers, the .154 inch pin size found on the vast majority of AR-15 receivers. If you happen to have a large pin Colt-pattern lower, this part will not be a direct fit, so it's worth double checking your pin size before ordering.
Most builders can swap this in themselves with a basic punch set and a few minutes of patience. That said, rifles running heavier buffer springs can make disassembly trickier, so if you're not confident pulling apart your trigger group, having a gunsmith handle it keeps things simple.
Nickel boron is harder and slicker than standard phosphate finishes, so it reduces friction between moving parts and resists carbon buildup better over time. That usually shows up as a smoother, more consistent trigger break and less grit creeping in between cleanings.
Yes, it's designed to work as a standalone drop-in part alongside your existing mil-spec trigger and hammer. It doesn't require you to replace the rest of your fire control group to get the benefit.
| UPC | 855899003096 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 1-NIBXD |
You must be logged in to post a review.
Reviews
There are no reviews yet.