$24.99
Out of stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Carbon buildup inside the bolt carrier is one of those quiet problems that sneaks up on an AR-15. It packs into the recess behind the bolt tail, keeps the bolt from seating fully, and eventually shows up as sluggish cycling or outright malfunctions. This scraper from Brownells is built specifically to reach that hard-to-clean pocket and break the crud loose so your rifle keeps running the way it should.
The tool has a carbon steel body paired with a high-impact polymer handle, so you get real bite against baked-on fouling without a grip that tears up your hand. Operation is about as simple as it gets: seat it in the carrier, give it a few twists, and the tool shears the heavy carbon away from the inner walls. Flip the carrier over, tap it out, and the loosened chunks fall free. No solvents required to knock down the worst of it, though a little cleaner never hurts once the heavy stuff is gone.
This is a big-buildup tool, and it shines at exactly that job. Folks who run steel-cased ammo, put a lot of rounds downrange between cleanings, or just want to stop fighting the carbon ring will get the most out of it. It's worth setting expectations: the scraper does the heavy lifting and knocks out the bulk of the fouling fast, but you'll likely still want a patch or a smaller pick to chase the last thin film in the corners. That's normal for any carrier scraper and not a knock on this one.
Made to fit standard AR-15 and M-16 carriers, it's a natural addition to any cleaning kit or armorer's bench. A quick scrape during your regular breakdown keeps carbon from ever getting a foothold, which means fewer cycling headaches and a rifle that stays reliable range trip after range trip. Simple tool, one job, and it does that job well.
It's built to reach the recess inside the bolt carrier and scrape out the carbon that packs in behind the tail of the bolt. That's the spot most brushes and patches can't touch, and leaving it dirty is a common cause of sluggish cycling. A few twists and the tool shears the buildup loose.
It's designed to work the carbon out of the carrier recess without harming the parts. Let the tool do the work with a twisting motion rather than forcing it, and you'll knock the fouling loose while leaving the finish alone. Going easy also keeps the tool lasting longer.
It excels at removing the heavy, packed-in carbon quickly, which is the buildup that actually causes function problems. Once the big stuff is out, you'll usually want a patch or small pick to chase the last thin film in the corners. That's typical of any carrier scraper and just part of a normal cleaning routine.
Yes, it's made to fit standard AR-15 and M-16 bolt carriers. If you're running a mil-spec carrier group, it'll seat right in. It's a handy addition to a cleaning kit or an armorer's bench.
| UPC | 050806033221 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 400014SELLABLE |
You must be logged in to post a review.
Reviews
There are no reviews yet.