$66.99
2 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
If you run an RCBS Pro Chucker 7 and load pistol brass, the #27 shell plate is the piece that holds everything in place while the press does its work. This plate is sized to fit the .40 S&W, 10mm Auto, and .357 SIG case head, so every case sits square under the dies across all seven stations. It's machined to tight tolerances and built from steel, which is what you want in a part that sees constant rotation and pressure during a reloading run.
RCBS shell plate numbers line up with their shell holder numbers, and the #27 is the one you reach for with .40 S&W, 10mm Auto, and .357 SIG brass. These three share a case head, so a single plate covers all of them. If you shoot a mix of those calibers, you only need the one plate to keep them all feeding through your Pro Chucker 7.
Caliber changes on the Pro Chucker 7 come down to matching the right shell plate to the brass you're running. Pulling one plate and dropping in the #27 is a quick job, and pairing it with the matching die plate makes jumping between calibers about as painless as it gets on a progressive setup. The plate seats cleanly and indexes with the press so cases rotate station to station without fuss.
This is the real-deal RCBS factory part, not an aftermarket copy, so fit is exactly what the press was designed around. It's made in the USA and backed by RCBS, which has been making reloading gear for decades. Grab the #27 if your pistol loading leans toward .40, 10mm, or .357 SIG and you want your Pro Chucker 7 running the way it should.
The #27 plate is sized for .40 S&W, 10mm Auto, and .357 SIG. All three cartridges share the same case head, so one plate covers the whole group. RCBS shell plate numbers match their shell holder numbers, which is handy if you're cross-referencing a chart.
This is specifically the seven-station plate for the Pro Chucker 7. RCBS makes a separate shell plate line for the five-station Pro Chucker 5, so make sure you're matching the plate to your exact press. The number stays the same across both, but the plate itself is different, so grab the Pro Chucker 7 version for a seven-station machine.
Yes, this is the factory RCBS shell plate, part number 88965, made in the USA. Since it's built to RCBS specs, it drops right into the Pro Chucker 7 the press was designed around. It's also backed by the RCBS limited lifetime warranty.
The shell plate handles the case head side of the swap, but a full caliber change also means matching your dies and die plate to the new cartridge. Running a dedicated die plate for each caliber speeds things up considerably. Pair the #27 with the right dies and you're set for .40, 10mm, or .357 SIG.
| UPC | 076683889652 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 88965 |
| Shipping Weight | 0.475 |
You must be logged in to post a review.
Reviews
There are no reviews yet.