.22 Caliber RCBS MatchMaster Trimmer 3-Way Cutter Head 90230

Description

If you already run the RCBS MatchMaster Precision Case Trimmer, this .22 caliber 3-Way Cutter Head is the accessory that gets your workflow dialed for the .22 bore family. It arrives assembled and set up for the caliber you need, so there is no fiddling with loose parts before you get to the bench. The three-way design means every pull does the heavy lifting at once: trimming to length, deburring the outside, and cutting a clean inside chamfer in a single smooth motion.

Why the .22 Caliber MatchMaster Cutter Head Earns Its Spot

The cutting is handled by adjustable carbide blades, which hold an edge far longer than standard steel and keep your trim length and chamfer consistent case after case. Carbide is the right call for anyone running volume, since you are not stopping to touch up or swap dull cutters mid-session. The adjustability lets you fine-tune the chamfer and deburr to your preference, which matters when you are chasing repeatable neck tension and smooth bullet seating on .22 bore cartridges like 223 Rem and 22-250.

Built Like the Rest of the MatchMaster Line

This cutter head is machined from 416 stainless steel and custom finished for durability, so it matches the precision standards RCBS built the MatchMaster system around. The whole MatchMaster platform was co-developed with Henderson Precision, and these heads are made to the same tolerances that make the trimmer repeatable down to very fine adjustments.

One thing worth being clear on: this head is designed specifically for the MatchMaster Precision Case Trimmer and is not meant for the older Trim Pro series or other RCBS trimmers. If you want to add another caliber to your setup or keep a dedicated head ready for your .22 bore brass, this is the piece that gets you there without any guesswork.