$40.99
26 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The Die Free Co Full Stop earns its name by doing the job of three separate accessories in one compact footprint. Run it as a hand stop to keep your support hand from sliding toward the muzzle, flip your setup and it works as a finger stop for a C-clamp grip, and press it against a wall or vehicle frame and it becomes a solid barricade stop. This OD green version bolts to any M-LOK slot and gives you a fixed point to build consistent mechanics around.
A slick handguard gives your support hand nothing to reference, which is where a stop like this pays off. Anchoring your grip at a repeatable spot means you hit the same hold every presentation, and it lets you actively pull the rifle back into your shoulder for better recoil control. On a short-barreled or suppressed build, it also keeps your fingers back and away from the muzzle or a hot can. All that in a piece that weighs about eight tenths of an ounce, so it disappears on the rifle until you need it.
Die Free Co machines the Full Stop from 6061-T651 aluminum and hits it with a MIL-A-8625 Type III hardcoat anodized finish, so it shrugs off range abuse and holds up against bracing on rough cover. It measures roughly 1.3 inches long, 1.36 inches tall, and 0.6 inches wide, keeping it low and out of the way of lights, cameras, or other rail accessories. It's made in the USA.
Installation is quick with a 3/32 Allen bit. Bias the stop toward the rear of the firearm so the M-LOK rear recoil lug seats into the slot, then torque it to 25 in-lbs with a 35 in-lb ceiling. A dab of blue Loctite is a smart call to keep it locked in through recoil. Where you mount it comes down to your grip, but most folks land it somewhere between halfway and three-quarters down the handguard.
It's built to pull triple duty. Use it as a traditional hand stop to keep your support hand off the muzzle, as a finger stop for a C-clamp grip, or as a barricade stop when you're bracing against a wall, post, or vehicle. The whole idea behind the Full Stop is one small part covering three roles.
The Full Stop is designed for M-LOK slots, so it works on any M-LOK compatible handguard or handguard section. It won't mount to Picatinny or KeyMod rails without an adapter. If your rail has M-LOK slots, you're good to go.
Grab a 3/32 Allen bit, bias the stop toward the rear so the M-LOK recoil lug seats in the slot, and torque it to 25 in-lbs with a 35 in-lb max. A drop of blue Loctite helps keep it put under recoil. Most people run it somewhere between halfway and three-quarters down the handguard, though C-clamp shooters often prefer it a little farther forward.
Yes. It's machined from 6061-T651 aluminum and wears a Type III hardcoat anodized finish, which is the same tough treatment used on hard-use gear. That construction lets you lean into barricades and rough surfaces without worrying about chewing it up.
| UPC | 850079932111 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | FS-M-ODG |
| Color | Olive Drab Green |
| Model | |
| Product Type | Foregrip |
| Shipping Weight | 0.0 |
You must be logged in to post a review.
Reviews
There are no reviews yet.