Description
If you run more than one caliber on a Lyman T-Mag press, an extra turret head is one of the smartest upgrades you can make. Rather than tearing down a loaded turret and readjusting dies every time you switch cartridges, you keep a dedicated turret set up for each caliber and swap the whole head. Your sizing, seating depth, and crimp settings stay locked exactly where you dialed them, which saves real time at the bench and keeps your loads consistent run after run.
What the T-Mag II Extra Turret Brings to the Bench
This is the same six-station turret head that ships standard with the T-Mag II press, so fit and function are a given. Each of the six stations is threaded for standard 7/8"-14 dies, which fits virtually any brand of reloading die on the market. That station count is the big draw here. You've got room for a full three-die pistol set along with a powder-through expander and a separate crimp die, or a complete rifle die set with stations to spare. Reloaders who work 38/357 and similar cartridges that benefit from separate seating and crimping steps appreciate having the extra real estate.
Fitment and Build of the T-Mag II Extra Turret
This genuine Lyman part carries MPN 7726153 and indexes on the T-Mag's turret retention system, so dies return to the same position every time you cycle through. Beyond the current T-Mag II, it also fits the original T-Mag press, so older presses aren't left out. Reloaders consistently describe these turret heads as thick and solidly built, which is exactly what you want holding your dies in alignment under full sizing pressure.
Staying Organized With the T-Mag II Extra Turret
Pre-loaded turrets store flat, so once you've got a couple set up for your most-used cartridges, a turret stacker or stand keeps them protected and ready to grab. For anyone loading enough volume to justify leaving dies set, this is the accessory that pays you back in saved setup time.
Key Specifications
- Manufacturer: Lyman
- Manufacturer Part Number (MPN): 7726153
- UPC: 011516761538
- Type: Spare Turret Head
- Die Stations: 6
- Die Thread: 7/8"-14
- Compatibility: Lyman T-Mag II and original T-Mag presses
- Country of Origin: Made in USA
- Shipping Weight: 3 lbs
What’s Included
- Lyman T-Mag II Extra Turret (six-station turret head)
Frequently Asked Questions
Which presses does the Lyman T-Mag II Extra Turret fit?
It's made for the Lyman T-Mag II turret press and is the identical head that ships with that press from the factory. It also fits the original T-Mag press, so older setups are covered. It's a genuine Lyman part under MPN 7726153, not a generic aftermarket substitute.
How many dies can the T-Mag II Extra Turret hold?
The turret has six stations, each threaded for standard 7/8"-14 dies. That's enough room for a full pistol set with a powder die and crimp die, or a complete rifle die set with stations left over. Any standard 7/8"-14 die fits regardless of brand.
Does the extra turret come with dies or a shellholder?
No, this is the bare turret head only. You install your own dies and lock the rings so the turret returns them to the same position each session. It's meant to be a dedicated, pre-set head for one caliber so you can swap and go.
Why would I want a second turret instead of just resetting my dies?
Breaking down and readjusting a turret every time you change cartridges eats up bench time and risks shifting your seating depth or crimp. With an extra turret you keep each caliber staged and locked in, then swap the whole head in seconds. For anyone loading multiple cartridges regularly, it pays for itself in saved setup time and repeatable results.



Reviews
There are no reviews yet.