$24.99
6 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Springs are the quiet workhorses of an AR-15, and they wear out long before most people think to check them. This Sprinco USA kit tackles two of the big ones in a single package: a standard-power buffer spring for your rifle-length tube and the heavy-duty XP 5-coil extractor spring for your bolt. It's a low-effort refresh that pays off in cleaner cycling and fewer extraction hiccups down the line.
Both springs are wound from certified valve-quality chrome silicon wire, the same class of material used in high-RPM racing engine valve springs. Sprinco heat treats, stress relieves, and shot peens the buffer spring after winding, which is why these hold their load spec far longer than the music wire found in most OEM and budget aftermarket springs. Consistent spring pressure across the whole duty cycle means fewer malfunctions and a more predictable-feeling gun.
The XP 5-coil extractor spring carries a heavier load than a standard mil-spec spring, so it clamps down harder on the case rim and keeps feeding reliably even when your rifle is running dirty. That extra grip makes it a favorite for 16-inch and shorter builds, including suppressed setups where things get gunky fast. The heavier load also means you can skip the D-Fender ring entirely. Run the 5-coil spring with either the black extractor insert or a Viton O-ring, but not both at once.
Swapping these in is a straightforward job at the bench with basic tools. The buffer spring drops right into a rifle-length tube, and the extractor spring goes in during a normal bolt teardown. If you shoot a lot, these are the kind of springs you install once and largely forget about, which is exactly the point.
The kit pairs a standard-power rifle buffer spring with the heavy-duty XP 5-coil extractor spring. It also comes with the mil-spec black extractor insert and a Viton O-ring for the extractor spring. That covers both the buffer tube and the bolt in one package.
No, use one or the other, never both at the same time. The 5-coil extractor spring already carries a heavier load than a standard spring, so it grips the case rim hard on its own. Many builders run the spring with just the insert, though the Viton O-ring is there if you prefer it. Sprinco does not recommend a D-Fender ring with the 5-coil spring.
It's reliable across all 5.56 barrel lengths and really shines on 16-inch and shorter builds, including suppressed guns that run dirty. On longer 18-inch-plus barrels where you're saving brass for reloading, the heavier load can be a bit aggressive on case rims, so the 4-coil enhanced spring is the friendlier pick there. For most carbine-length setups, the 5-coil is a great match.
A long time. The chrome silicon wire and post-winding treatment give these springs an extended duty cycle that outlasts typical OEM springs by a wide margin. Sprinco has documented over 200,000 rounds on a single extractor spring, so for most owners this is a set-it-and-forget-it upgrade.
| UPC | 657780250028 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 25002 |
You must be logged in to post a review.
Reviews
There are no reviews yet.