Description
Neck tension is one of those little details that separates good handloads from great ones, and a bushing like Redding's .250 steel neck sizing bushing is how you take control of it. Instead of working the brass neck harder than it needs, you pick the exact diameter that gives you just enough grip on the bullet. This one measures .250 inches and carries Redding's 73-series part number, 73250.
What the .250 Redding Steel Bushing Brings to the Bench
This is a heat-treated steel bushing with the sizing diameter hand polished to a surface hardness of Rc 60-62. That hard, smooth finish is what keeps sizing effort low and, with a little lube on the neck, leaves the brass clean without drag marks. It's the standard steel version in Redding's lineup, so it machines true to its marked size and holds up through a lot of loading cycles.
Fitting the 73250 Bushing Into Your Setup
Redding neck sizer bushings share the same 1/2-inch O.D. by 3/8-inch long external dimensions, which means this .250 bushing freely interchanges in any Redding bushing-style neck sizing die. It also works in Wilson-style bushing dies, so if you've already got a setup running you can likely slot this one right in. Every bushing is clearly marked with its size for quick identification on a cluttered bench.
Picking the Right Diameter
Sizing bushings run in .001-inch increments and cover calibers from .17 all the way up to .338, so getting the right number matters. The usual method is to measure the outside neck diameter of a loaded round with a good micrometer, then subtract about .001 to .002 inches to account for brass springback and the tension you want on the bullet. Get that figure right and this bushing does the rest, giving you repeatable neck tension round after round. Made in the USA.
Key Specifications
- Manufacturer: Redding
- Manufacturer Part Number: 73250
- UPC: 611760732508
- Bushing Diameter: .250 in
- Style: 73 Series Steel
- Material: Heat-Treated Steel
- Surface Hardness: Rc 60-62
- External Dimensions: 1/2 in O.D. x 3/8 in Long
- Fit: Redding Bushing-Style Neck Dies, Wilson-Style Bushing Dies
- Caliber Range Covered: .17 to .338
- Country of Origin: United States
What’s Included
- One Redding .250 heat-treated steel neck sizing bushing (73250)
Frequently Asked Questions
Will this .250 Redding bushing fit my neck sizing die?
It fits any Redding bushing-style neck sizing die, since all of their steel and titanium nitride bushings share the same 1/2-inch O.D. by 3/8-inch long external dimensions. It also interchanges with Wilson-style bushing dies. If your die is built for bushings, this one drops right in.
How do I know if .250 is the right bushing size for me?
Measure the outside neck diameter of a loaded cartridge with a precision micrometer, then subtract about .001 to .002 inches to allow for brass springback and bullet tension. The number you land on is the bushing diameter you want. If that math comes out to .250, this is your bushing.
What's the difference between this steel bushing and the titanium nitride version?
Both are heat-treated steel with the same dimensions and the same Rc 60-62 surface hardness, so they size brass the same way. The titanium nitride version adds a TiN coating that bumps up the surface hardness a touch more and cuts sizing friction. This listing is the standard steel bushing, which is the go-to for most reloaders.
Do I still need to lube the case neck with this bushing?
A little lube on the neck helps the bushing glide and keeps the brass clean. With a lubed neck, the hand-polished steel bushing leaves no marks on the necks. Running it dry works but adds unnecessary effort and wear.




Reviews
There are no reviews yet.