Description
If you're reloading for a 6mm Remington or .244 Remington and you want your brass to stay true to your chamber, this Lee collet die is one of the smartest tools you can have on the bench. Instead of working the entire case body, it sizes only the neck, squeezing it against a precision steel mandrel to create a perfectly aligned case neck with minimal bullet runout. That alignment is where accuracy lives, and it's why precision handloaders keep coming back to the collet design.
This is the collet die only, built with standard 7/8"-14 threads so it drops right into any common single-stage or turret press. It also deprimes the case as it sizes the neck, so you're handling one less step on the way to a finished round.
What the 6mm Remington Collet Die Does Differently
Traditional sizing dies rely on case lube and work the brass hard, which shortens its life over time. The collet approach skips the lube entirely because the neck is pressed against the mandrel rather than forced through a ring. The result is clean brass, less effort at the handle, and cases that stay fire-formed to your rifle's chamber. For folks running the same brass season after season, that fire-formed fit pays off in both consistency and longevity.
Getting the Most From Your .244 Remington Neck Sizing Die
One thing worth knowing: Lee updated the collet in 2019 so a small portion of the neck now protrudes past the sizing section. That change leaves the top of the neck in its fire-formed condition and creates a slight natural flare, which makes seating bullets easier and more concentric. For best results, only run cases that have been fired in your own firearm, and seat your bullets out close to the rifling where this die really shines. Keep in mind the collet design is meant for bolt guns and single shots rather than autoloaders, slide, or lever actions.
It's a simple, rugged tool that does one job extremely well. If neck sizing is part of your accuracy plan, this is a proven piece of American-made gear to build around.
Key Specifications
- Manufacturer: Lee Precision
- Manufacturer Part Number: 91006
- Model Number: 91006
- UPC: 734307910068
- Cartridge: 6mm Remington / .244 Remington
- Die Type: Collet Neck Sizing Die (Die Only)
- Thread Size: 7/8"-14
- Gun Type: Rifle
- Lube Required: No
- Deprimes Case: Yes
- Country of Origin: United States
- Material: Steel collet with precision mandrel
What’s Included
- Lee Precision 6mm Remington / .244 Remington collet neck sizing die (die only)
Frequently Asked Questions
Does the 6mm Remington collet neck sizing die require case lube?
No. The collet design squeezes the case neck against a precision mandrel instead of forcing the brass through a sizing ring, so no lubrication is needed. That keeps your brass clean and saves you a messy step on the bench.
Can I use this collet die on both 6mm Remington and .244 Remington brass?
Yes. The two cartridges share the same case dimensions, so this single die covers both 6mm Remington and .244 Remington. It's designed to size the neck only while leaving the case body fire-formed to your chamber.
Is this a full die set or just the neck sizing die?
This is the collet neck sizing die only, not a complete set. It uses standard 7/8"-14 threads so it fits common single-stage and turret presses, and you'll pair it with your own seating die to finish loaded rounds.
What kind of rifles is the collet neck sizing die best suited for?
It's intended for cases fired in your own bolt action or single shot rifle, since neck-only sizing preserves that fire-formed fit. Lee does not recommend collet neck sizing for autoloaders, slide, or lever action guns where full-length sizing is usually needed for reliable feeding.



Reviews
There are no reviews yet.