$38.72
3 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
If you're loading your own 7mm-08 and want brass that chambers smooth and lasts, this is one of those tools that earns a permanent spot on the bench. The L.E. Wilson 7mm-08 Remington Case Gage is a one-piece, non-adjustable steel gage that checks two of the most important measurements in rifle reloading: headspace and case length. You drop a case in, read where it sits against the min and max steps, and you know exactly where you stand.
This gage measures datum-to-head length, which is the headspace dimension that determines how your round stops against the chamber, along with overall case length so you know when it's time to trim. The idea is to measure a case in its as-fired condition first, note the headspace, then resize and drop it back in to see how far you're setting the shoulder back. Flip it over on a flat surface and run a straightedge across the stepped end to check trim length against the min and max marks. One tool, both jobs. Worth noting, it does not measure body diameters, and it's built to be used with fired brass as the baseline for setting up your full-length sizing die.
The real value here is consistency and not overworking your brass. By setting your sizer to bump the shoulder back just a thousandth or two below chamber headspace, you get reliable chambering without stretching cases more than they need, which means fewer case-head separations and more loadings out of each piece. It pairs perfectly with a caliper or Wilson's own case gage depth micrometer if you want precise numbers instead of just eyeballing the steps.
L.E. Wilson has been a family-run operation since 1927 and literally invented the case gage back in 1935, so the design is proven. For bolt-gun shooters and anyone chasing tighter, more consistent 7mm-08 loads, it's a simple, no-batteries, won't-wear-out piece of kit that just works.
It checks two things: headspace, which is the datum-to-head length that controls how your round sits in the chamber, and overall case length so you know when brass needs trimming. You drop a case in and compare where it sits against the min and max steps on each end. It does not measure case body diameters.
You can get a usable read just by eyeballing where the case sits relative to the min and max steps, which is handy at the bench. For precise numbers, most reloaders pair it with a caliper or L.E. Wilson's case gage depth micrometer to measure exactly how far the shoulder is being set back. Either way, it helps you dial your sizing die in with confidence.
No, this is a one-piece, non-adjustable gage machined to SAAMI reference dimensions for 7mm-08 Remington. That fixed design is exactly what makes it a repeatable reference you can trust load after load. L.E. Wilson does offer adjustable gages in a separate line if that's what you're after.
It's designed to be used with fired and resized brass as the basis for setting up your full-length sizing die and trimming. You can certainly drop a loaded or fired round in to check headspace and length, but its main job is helping you tune your reloading process. Measure a case as-fired first, then size and re-check to see your shoulder setback.
| UPC | 857949005142 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | CG-7M08 |
You must be logged in to post a review.
Reviews
There are no reviews yet.